Study on Tool Wear In-Process Estimation for Ball End Mill Using Rotation Control Air Turbine Spindle

Abstract

This paper introduces a method for in-process tool wear estimation of an air turbine spindle, which is equipped with a rotation control system for ultra-precision milling. Previous investigations revealed that the pressure of the compressed air for supply that is used to control the rotational speed and tool wear at the time when steady wear occurs, maintains a linear relationship when processing SKD61 steel. In addition, the extent to which the supply pressure changed was reduced after chipping occurred. Therefore, the possibility exists that the tool wear can be estimated by obtaining the supply pressure during processing. The purpose of this paper is to propose the evaluation of an in-process tool wear estimation method, and to evaluate its validity. An estimation method is necessary as this would allow the amount of tool wear to be estimated and abnormal wear of occurrence to be detected. Because of the linear relationship between the air pressure and the amount of tool wear, the latter can be estimated by plotting the approximately linear relationship of the tool wear as a function of the air pressure. The proposed estimation method for processing the results obtained for SKD61, is capable of estimating the relative error of the measured value within 0.2 against the estimated value at the time. Furthermore, the occurrence of abnormal wear is determined from the amount of change in the supply pressure. Thus, SKD11 steel was processed for the proposed estimation method to verify whether it is valid for cutting high hardness steel. As a result, for SKD11 the estimation method produced estimation results similar to those obtained for SKD61. Therefore, the suggested estimation method is likely to be effective for high-hardness steel cutting.

Research on aerodynamic characteristics of two-stage axial micro air turbine spindle for small parts machining

“…10,14 At the inlet pressures of 300 KPa, 224 KPa, and 180 KPa, the input and output characteristics of the air turbine spindle were tested. Using formulae (4), (5), and (6), we calculated the turbine efficiency and the spindle efficiency. The relationship between the turbine efficiency, velocity coefficient, and the inlet pressure is drawn, as shown in Figure 15.…”

“…1–3 As a key component in micro-cutting technology, a micro-spindle should not only ensure a high rotation speed and high turning accuracy but also have a compact structure, compact size, and convenient installation. 4–6 Because of their advantages such as easy to realize high speed, no heating during operation, compact structure, and high power density and durability, air turbines have been widely used in micro-spindles, and researchers have carried out a number of relevant studies.…”

Breakage Detection Based on the Breakage Mechanism of Small-Diameter Drills

“…Previous studies have confirmed that the high-precision quick-response pneumatic pressure regulator (HPQR)has been used to maintain a constant rotation speed during machining [1,2]. It has been found that estimating endmill wear from the supply pressure is possible [3], and the effectiveness of the endmill wear estimation method in high hardness steel has been confirmed [4].…”