UDP Pervasive Protocol Implementation for Smart Home Environment on MyRIO using LabVIEW

Kurniawan, Wijaya; Ichsan, Mochammad Hannats Hanafi; Akbar, Sabriansyah Rizqika

doi:10.11591/ijece.v8i1.pp113-123

Cited by 4 publications

(3 citation statements)

References 14 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The demand has been increasing and continuously to use internet systems continuously, which caused and birthed the problem of congestion [1]- [3]. It needs appropriate ways to reduce lost time and loss of data or late access to data with the importance of arriving at the right time [4]- [6]. The use of different control methods to obtain the best performance for the work of similar systems that operate in real time [7]- [9].…”

Section: Introductionmentioning

confidence: 99%

Simulation model of ANN and PID controller for TCP/AQM wireless networks by using MATLAB/Simulink

Jaber

Shneen

2023

IJEECS

View full text Add to dashboard Cite

<p>The wireless network transmission control protocol/active queue management (TCP/AQM) is a network that was chosen as a topic for research a basis is laid to simulate the proposed network and to conduct the simulation under certain conditions. To manage the queue control protocol (TCP/AQM) was chosen. The solution for many modern systems depends on placing additional units called controllers, which work to improve the performance of the work of the systems. The current simulation system can be described according to the test cases that were conducted, where four test cases were identified with sequential steps. In this work there are two control methods by simulation and mathematical model of wireless network TCP/AQM with proportional, integral and derivative (PID) controller and neural network. Simulation is conducted for cases in order to determine the performance of each case through comparison according to appropriate criteria to determine the best. The first case is a wireless communication network system with with a traditional controller PID type. The second is a wireless communication network system, a large neural network controller. Simulations were conducted to choose the best methods among those suggested for nonlinear systems and to enhance and achieve the possibility of adopting MATLAB to perform the required simulation.</p>

show abstract

Section: Introductionmentioning

confidence: 99%

Simulation model of ANN and PID controller for TCP/AQM wireless networks by using MATLAB/Simulink

Jaber

Shneen

2023

IJEECS

View full text Add to dashboard Cite

show abstract

“…The Internet is a network for transferring data between users of different disciplines as quickly as possible [1]- [3]. For every system, including the web-based system, there are problems that cause poor performance, including data loss or delays [4]- [6]. The reason for this is the large number of data as a result of the large number of users, which causes congestion resulting from the waiting list [7]- [9].…”

Section: Introductionmentioning

confidence: 99%

Flower Pollination Algorithm to Tune PID Controller of TCP/AQM Wireless Networks

Eissa¹,

Shneen²,

Ali³

2023

Journal of Robotics and Control

View full text Add to dashboard Cite

The current study aims to conduct a simulation that is useful in developing an appropriate design that addresses the problem of congestion in the Internet network through controlling the queue of the router. The simulation is conducted through the proposed model for simulation with different control systems that help in raising the quality of performance such as traditional Proportional Integral Derivative (PID) and advanced optimal by Flower Pollination Algorithm (FPA). It depends for Transmission Control Protocol/ Active Queue Management( TCP/AQM )simulation model for a linear system and another non-linear system. To adjust the network work and raise the level of performance, different control systems were chosen, taking into account all the things that appear through conducting experiments and for different purposes. One of the most important things that must be taken into consideration is the system disturbances as a result of the volume and values of the data, causing congestion . It was shown through the results of the experiments that were conducted considering the cases of the linear and nonlinear system to pass data traffic in the network and by adopting the different techniques of the control units, the preference of optimizasion systems over the traditional ones, as well as the preference of the traditional over without control in close loop, is the improvement of the performance of linear systems compared to the open and closed system without control. The simulation results showed that very clear the superiority of the optimization by FPA-PID controller over the conventional system (PID) , as well as very clear the superiority of the traditional system (PID)over closed system without control and open loop system.

show abstract

“…Previous research is conducted by designing and implementing UDP Pervasive on LabVIEW [9] and implementing on MyRIO [16] this research is originally extended from that previous system that communicate over cloud server. This system is designed by having a Host and a Client.…”

Section: Introductionmentioning

confidence: 99%

UDP Pervasive Protocol Integration with IoT for Smart Home Environment using LabVIEW

Ichsan

Kurniawan

Akbar

2018

IJECE

Self Cite

View full text Add to dashboard Cite

Pervasive computing is an environment which is used and integrated into every object and activities to meet human needs and its existence isn’t perceived as something specific. The concept of Smart Home is to assist human needs in an everyday object that performs controls or being controlled. Based on previous research the used communication protocol is UDP (User Datagram Protocol) and the programming language is LabVIEW. UDP is used because it does not require handshaking in the broadcast process, as well as on the use of memory more efficient than other protocols. Devices which perform controls called Host and which is controlled called Client. Both of them (Things) have an ability to send data to the Internet without any human interaction. So this research wants to conduct pervasive protocol between Host and Client which each device is integrated with the Internet of Things (IoT). Data are posted at dweet.io that is a cloud server website that contains a simple online data submission which has free services. This research is conducted to measure the communication performance between host to client, host to cloud server and client to cloud server that represents household equipment.

show abstract

UDP Pervasive Protocol Implementation for Smart Home Environment on MyRIO using LabVIEW

Cited by 4 publications

References 14 publications

Simulation model of ANN and PID controller for TCP/AQM wireless networks by using MATLAB/Simulink

Simulation model of ANN and PID controller for TCP/AQM wireless networks by using MATLAB/Simulink

Flower Pollination Algorithm to Tune PID Controller of TCP/AQM Wireless Networks

UDP Pervasive Protocol Integration with IoT for Smart Home Environment using LabVIEW

Contact Info

Product

Resources

About