This study presents the results of experimental work on the production and examination of samples of laminated polymetallic products made by wire-feed electron-beam additive technology using the technique of controlled filament feeding into the melt bath. The structure of the products based on M1 copper and AMg5 aluminum alloy combines metallic and intermetallic layers with the presence of a gradient transition between the phases. Inside the layers with a transition structure the distribution of intermetallic phases can be of different types. The microhardness values of the different structural constituents of the samples differ by more than a factor of 16. The mechanical properties of the material of the transition layers are characterized by low strength and low plasticity. In the structure of the intermetallic layers and at the boundary between them the formation of defects in the form of cracks and delaminations is observed.

This paper is devoted to using multi-pass friction stir processing (FSP) for admixing 1.5 to 30 vol.% copper powders into an AA5056 matrix for the in situ fabrication of a composite alloy reinforced by Al-Cu intermetallic compounds (IMC). Macrostructurally inhomogeneous stir zones have been obtained after the first FSP passes, the homogeneity of which was improved with the following FSP passes. As a result of stirring the plasticized AA5056, the initial copper particle agglomerates were compacted into large copper particles, which were then simultaneously saturated by aluminum. Microstructural investigations showed that various phases such as α-Al(Cu), α-Cu(Al) solid solutions, Cu3Al and CuAl IMCs, as well as both S and S’-Al2CuMg precipitates have been detected in the AA5056/Cu stir zone, depending upon the concentration of copper and the number of FSP passes. The number of IMCs increased with the number of FSP passes, enhancing microhardness by 50–55%. The effect of multipass FSP on tensile strength, yield stress and strain-to-fracture was analyzed.

This work studied the possibility of producing multimaterials consisting of aluminum bronze CuAl9Mn2 and nickel-based superalloy Inconel 625 by double-wire electron beam additive manufacturing. Samples with 5%, 15%, 25%, and 50% of the nickel-based alloy in aluminum bronze were produced for the research. The structural features of these multimaterials were analyzed, and tensile properties, microhardness, and dry sliding friction properties were measured. The results showed that 50% of the nickel-based alloy in the multimaterial composition provides the formation of a dendritic structure. Such a material shows worse values of ductility and wear resistance. Samples containing 5%, 15%, and 25% of Inconel 625 provide similar friction coefficient values, whereas, with increasing concentration of the nickel-based alloy, the material’s ultimate tensile strength and microhardness increase significantly.

This work explores the possibility of using friction stir processing to harden the Ti-6Al-4V titanium alloy material produced by wire-feed electron beam additive manufacturing. For this purpose, thin-walled workpieces of titanium alloy with a height of 30 cm were printed and, after preparation, processed with an FSW-tool made of heat-resistant nickel-based superalloy ZhS6U according to four modes. Studies have shown that the material structure and properties are sensitive to changes in the tool loading force. In contrast, the additive material’s processing direction, relative to the columnar grain growth direction, has no effect. It is shown that increasing the axial load leads to forming a 𝛽-transformed structure and deteriorates the material strength. At the same time, compared to the additive material, the ultimate tensile strength increase during friction stir processing can achieve 34–69%.

No abstract