BackgroundSLCO1B1 polymorphisms are relevant in statin pharmacokinetics. Aim of this study was to investigate the genetic variability and haplotype profile of SLCO1B1 polymorphisms in Roma and Hungarian populations. Genotypes of 470 Roma and 442 Hungarian subjects for c.388A > G, c.521T > C and c.1498-1331T > C polymorphisms were determined by PCR-RFLP assay. Using these SNPs eight different haplotypes could be differentiated.ResultsDifferences were found between Roma and Hungarians in SLCO1B1 388AA (24.5 vs. 45.5 %), GG (33.4 vs. 17.9 %) genotypes, AG + GG (75.5 vs. 54.5 %) carriers, in G allele frequency (0.545 vs. 0.362), respectively (p < 0.001). The most common SLCO1B1 haplotype was the ht8 (GTT) both in Roma (43.6 %) and in Hungarian (59.1 %) samples. The ht6 (GCT) was not present in Roma population samples Haplotype analyses showed striking differences between the Roma and Hungarian samples in ht4 (ATT, 37.2 % vs 20.8 %), ht5 (GCC, 1.15 % vs. 3.62 %) and ht8 (GTT, 43.6 % vs. 59.1 %) haplotypes (p < 0.01), respectively. Linkage disequilibrium analysis showed that the studied variants are in different linkage disequilibrium patterns depending on the ethnic origin.ConclusionsSimilarly to Caucasians the 388G is the minor allele in Hungarians, however, in Roma the 388A was found to be the minor allele contrary to Indians (India). The minor allele frequency of 521T > C and 1498-1331T > C SNPs are almost three times higher in Romas than in Indians (Singapore and Gujarati, respectively). Observed allele frequency for 1498-1331T > C polymorphism reflects the measured average European rates in Hungarians. The results can be applied in population specific treatment algorithms when developing effective programs for statin therapy.

Wine strains of Saccharomyces cerevisiae are usually homothallic diploids and show chromosome length polymorphism. We describe the analysis of a heterothallic strain heterozygous for the mating types a and alpha. Surveying cultures of the strain, we found a remarkable degree of heterogeneity in ploidy and in electrophoretic karyotype. The CHEF analysis of tetrads and dyads revealed an enormous variability of band patterns hampering the analysis of chromosome segregation. We propose that the instability of ploidy and chromosome polymorphism might be due to heterothallism that precludes the process "genome renewal" (MORTIMER et al. 1994) by selfdiploidization of spore clones.

Introduction: Inherited antithrombin (AT) deficiency is a heterogeneous disease. Due to low prevalence, only a few studies are available concerning genotype-phenotype associations. The aim was to describe the clinical, laboratory and genetic characteristics of AT deficiency in a large cohort including children and to add further laboratory data on the different sensitivity of functional AT assays.Patients and methods: Non-related AT deficient patients (n=156) and their family members (total n=246) were recruited. Clinical and laboratory data were collected, the mutation spectrum of SERPINC1 was described. Three different AT functional assays were explored.Results: Thirty-one SERPINC1 mutations including 11 novel ones and high mutation detection rate (98%) were detected. Heparin binding site deficiency (type IIHBS) was the most frequent (75.6%) including AT Budapest3 (ATBp3), AT Padua I and AT Basel (86%, 9% and 4% of type IIHBS, respectively). Clinical and laboratory phenotypes of IIHBS were heterogeneous and dependent on the specific mutation.Arterial thrombosis and pregnancy complications were the most frequent in AT Basel and AT Padua I, respectively. Median age at the time of thrombosis was the lowest in

According to environmental and safety-conscious behaviour in the 21th century, it is necessary to strive to reduce all those activities that cause environmental damage in every aspect of life. More emphasis should be placed on recycling, waste-handling and environmental-friendly solutions, due to the increased amount of waste caused by the penetration of plastics. Plastic manufacture is a constantly growing industry – especially the production of packaging – so the amount of plastic waste generated is also growing steadily. Only a part of the accumulated waste is recycled, another part is destroyed and the remaining amount will continue to pollute the environment. One form of destruction may be energy recovery or incineration. Destruction is a form of energy recovery or incineration which is subject to strict legal requirements in addition to other possible activities. It could pose a serious burden on the human and natural environment if the process is not properly controlled and monitored. This article writes of the situation that seemingly a growing amount of plastic waste is used in residential combustion appliances, of which adverse environmental and health effects the majority of citizens are not aware, so these will be shown in particular. In this article, we examine the environmental and health effects and harm caused by the burning of plastics in detail. We write this study with the purpose of drawing people’s attention to the importance of reducing the quantities of plastic waste and thus the environmental impact they cause as well as the human and environmental risks of incineration.

No abstract