Baghdad, considered one of the most polluted and populated cities in Iraq, waschoosen for mapping the distribution of air pollutants and the overall pollution levels by using the ArcGIS techniques. Six of main observation stations werechoosen in a particular location. Then, the recorded data from these stations were spatially interpolated using two types of ArcGIS interpolation techniques. The spatial interpolation techniques used in this work were Inverse distance weighting (IDW) and fuzzy logic. This study includes measuring the main air pollutants, which were nitrogen dioxide (NO2), sulfur dioxide (SO2), carbon monoxide (CO), nitrogen oxide (NOx), and nitrogen monoxide (NO) during the period from January 2018 to December 2018. The data recorded by the stations during the work period and the distribution maps of air pollutants, which resulted from spatial interpolation (IDW) method, showed that the concentration of NO2 was within the International limits of World Health Origination (WHO) which is about 0.11 ppm. SO2 concentrations were exceeding the WHO limits in all stations for the study area. The concentrations of CO ranged from 0.484 ppm to 7.027 ppm that were within acceptable limits of WHO standards that is 9 ppm. NOx concentrations ranged between 0.01506 ppm – 0.214 ppm, which were exceeding acceptable limits of WHO standards (0.01 ppm). The concentrations of NO did not exceed the WHO standard limits, which are 0.08 ppm. Finally, the fuzzsy logic method of spatial interpolation in ArcGIS was applied to evaluate the air pollution over Baghdad city.

No abstract

Air pollution is caused by various sources such as cars exhaust, energy sources, petrol stations, industrial activities, and other sources. The aim of this study was to measure some air pollutants gases, representing the results by Arc GIS maps over AL-Kut city and finding the ways for reducing them. Twenty samples have been taken using Global Positioning System (GPS) for measuring the main air pollutants (sulfur dioxide (SO2), nitrogen dioxide (NO2), carbon monoxide (CO), ozone (O3), total suspended particle (TSP), and particulate matters (PMs). The measurements were carried out by several specialized portable equipment at afive months starting from November 2015 to March 2016. The distribution maps resulted from ArcGIS 10.2, display that the highest concentrations of air pollutants were in the center and north of the study area. The highest concentrations of pollutants were in November and March, whereas lower concentrations observed during January period. The average monthly concentrations of (TSP) measured during the study period was (504.4 μg/m3, 359.5 μg/m3, 32.2 μg/m3, 324.8 μg/m3, and 392.45 μg/m3) from November 2015 to March 2016, these results were significantly higher than the permissible allowable limits of the Iraqi national (350 μg/m3) and international allowable limits (150 μg/m3), except for January is founded (32.2 μg/m3) within the acceptable limits due to heavy rainfall. the averages monthly concentrations of (CO), (6.567, 5.165, 4.08, 5.454 and 7.25 ppm) were lower than standards limits for five months, comparing with the Iraqi National limits (35 ppm) and WHO Limits (9 ppm). Pollutant concentrations such as (O3), were within acceptable limits of Iraqi and WHO limits at all period of study, while other air pollution gasses such as (SO2 and NO2), their concentrations over the study area were within the Iraqi national limits but slightly over the WHO limits.

The scarcity of safe drinking water is one of the problems faced by the majority of cities in the world. Kirkuk city is one of these cities, which suffer from a shortage of drinking water. People have adopted the use of different rooftop tanks to overcome this problem. This research focuses on studying the effect of storage time on the five main characteristics of drinking water, which include, acid index (pH), electrical conductivity (EC), total suspended solids (TSS), total dissolved solids (TDS), and turbidity (Tr). Three types of tanks were used predominantly (galvanized metal, plastic, and aluminum tanks). By analyzing the results, the characteristics of three samples of municipal source water obtained. Three samples were taken from each tank at different periods (4, 8, and 12 days). The results showed that the storage time affected the characteristics of drinking water. These characteristics differed from one tank to another. Metal tanks showed an increase in total dissolved solids, due to the evaporation process, even as plastic and aluminum tanks showed an increase in pH. The properties of all storage water tanks changed with times, but overall, the results were within the Iraqi limitation for drinking water. It was not easy to only depend on the results of this study to believe that any one type of water tank was better than the other, as the values of most of the variables studied had varied from one type to other. However, many studies have indicated a number of health risks, and most significantly with regard to plastic tanks, which are said to contain dangerous organic compounds that can be transferred to water. Metal tanks can cause zinc leakage, caused by a number of environmental factors at high levels. Aluminum tanks also can have an effect on the water in tanks.