Magnesium−sulfur batteries are considered as attractive energystorage devices due to the abundance of electrochemically active materials and high theoretical energy density. Here we report the mechanism of a Mg−S battery operation, which was studied in the presence of simple and commercially available salts dissolved in a mixture of glymes. The electrolyte offers high sulfur conversion into MgS in the first discharge with low polarization. The electrochemical conversion of sulfur with magnesium proceeds through two well-defined plateaus, which correspond to the equilibrium between sulfur and polysulfides (high-voltage plateau) and polysulfides and MgS (low-voltage plateau). As shown by XANES, RIXS (resonant inelastic X-ray scattering), and NMR studies, the end discharge phase involves MgS with Mg atoms in a tetrahedral environment resembling the wurtzite structure, while chemically synthesized MgS crystallizes in the rock-salt structure with octahedral coordination of magnesium.

Development of magnesium sulfur battery is accompanied with all known difficulties present in Li-S batteries, however with even more limited choice of electrolytes. In the present work, the influence of current collector on electrochemical mechanism was investigated in light of different reports where improved behavior was ascribed to electrolyte. Notable differences in cycling behavior are reported when Al current collector is replaced by Cu current collector independent of electrolyte. The initial reduction of sulfur follows similar reaction path no mater of current collector but formation of MgS can be in competition with formation of CuS in the presence of Cu cations. With the subsequent cycling cells prepared from cathodes deposited on Cu current collector show decrease in the voltage and formation of single plateau during cycling. The change corresponds to the involvement of Cu into the reaction and formation of redox couple Mg/CuS as determined by Cu Kedge XANES measurements. Corrosion of Cu foil is identified by SEM and serves as a source of Cu cations for the chemical reaction between Cu and polysulfides. Mg/CuS redox couple shows improved cycling stability, but theoretical energy density is severely reduced due to substitution of S with CuS as cathode active material.

Abstract