Thermophysical properties of a commercial 18650 LiCoO2 lithium-ion battery were determined using several different techniques, including analytical, numerical and experimental methods. A reasonable level of consistency was observed in values for heat capacity, which were found to be 972 ± 92 J/kg-K from the analytical method, 814 ± 19 J/kg-K from the numerical technique, and 896 ± 31 J/kg-K from calorimetry. The value for radial thermal conductivity with the best correlation to reported literature values obtained in this study (0.219 ± 0.020 W/m-K) was found via the numerical technique, and the axial thermal conductivity was found to be 22.3 ± 1.3 W/m-K. Values for heat capacity and thermal conductivity were also determined for aluminum and Teflon as controls, and all thermophysical properties in this work were found to be within, or very close to, reported literature values. These properties will aid in the development of ongoing and future lithium-ion battery simulation models and battery management systems.
Spinner, Neil S.; Hinnant, Katherine M.; Mazurick, Ryan; Brandon, Andrew; Rose-Pehrsson, Susan L.; and Tuttle, Steven G., "Novel 18650 lithium-ion battery surrogate cell design with anisotropic thermophysical properties for studying failure events" (2016
b s t r a c tCylindrical 18650-type surrogate cells were designed and fabricated to mimic the thermophysical properties and behavior of active lithium-ion batteries. An internal jelly roll geometry consisting of alternating stainless steel and mica layers was created, and numerous techniques were used to estimate thermophysical properties. Surrogate cell density was measured to be 1593 ± 30 kg/m 3 , and heat capacity was found to be 727 ± 18 J/kg-K. Axial thermal conductivity was determined to be 5.1 ± 0.6 W/m-K, which was over an order of magnitude higher than radial thermal conductivity due to jelly roll anisotropy. Radial heating experiments were combined with numerical and analytical solutions to the time-dependent, radial heat conduction equation, and from the numerical method an additional estimate for heat capacity of 805 ± 23 J/kg-K was found. Using both heat capacities and analysis techniques, values for radial thermal conductivity were between 0.120 and 0.197 W/m-K. Under normal operating conditions, relatively low radial temperature distributions were observed; however, during extreme battery failure with a hexagonal cell package, instantaneous radial temperature distributions as high as 43e71 C were seen. For a vertical cell package, even during adjacent cell failure, similar homogeneity in internal temperatures were observed, demonstrating thermal anisotropy.Published by Elsevier B.V.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.