The aim of this work was to compare and explore electron microscopy and atomic force microscopy (AFM) for structure determination of cellulose whiskers and their nanocomposite with poly(lactic acid). From conventional bright-field transmission electron microscopy (TEM) it was possible to identify individual whiskers, which enabled determination of their sizes and shape. AFM overestimated the width of the whiskers due to the tip-broadening effect. Field emission scanning electron microscopy (FESEM) allowed for a quick examination giving an overview of the sample; however, the resolution was considered insufficient for detailed information. Ultramicrotomy of nanocomposite films at cryogenic temperatures enabled detailed inspection of the cellulose whiskers in the poly(lactic acid) matrix by AFM. FESEM applied on fractured surfaces allowed insight into the morphology of the nanocomposite, although rather restricted due to the metal coating and limited resolution. Detailed information was obtained from TEM; however, this technique required staining and suffered in general from limited contrast and beam sensitivity of the material.

Microfibrillated cellulose (MFC) obtained by disintegration of bleached softwood sulphite pulp in a homogenizer, was hydrophobically modified by surface silylation with chlorodimethyl isopropylsilane (CDMIPS). The silylated MFC was characterized by Fourier transform infrared spectroscopy (FT-IR), atomic force microscopy (AFM), transmission electron spectroscopy (TEM), X-ray photoelectron spectroscopy (XPS) and white light interferometry (WLI). The degree of surface substitution (DSS) was determined using Si concentrations from XPS survey scans, as well as deconvoluted peaks in high-resolution C1s XPS spectra. The DSS values obtained by the two methods were found to be in good agreement. MFC with DSS between 0.6 and 1 could be dispersed in a non-flocculating manner into non-polar solvents, TEM observations showing that the material had kept its initial morphological integrity. However, when CDMIPS in excess of 5 mol CDMIPS/glucose unit in the MFC was used, partial solubilization of the MFC occurred, resulting in a drop in the observed DSS and a loss of the microfibrillar character of the material. The wetting properties of films cast from suspension of the silylated MFC were also investigated. The contact angles of water on the films increased with increasing DSS of the MFC, approaching the contact angles observed on super hydrophobic surfaces for the MFC with the highest degree of substitution. This is believed to originate from a combination of low surface energy and surface microstructure in the films.

Microfibrillated cellulose (MFC) was prepared by disintegration of bleached softwood sulphite pulp through mechanical homogenization. The surface of the MFC was modified using different chemical treatments, using reactions both in aqueousand organic solvents. The modified MFC was characterized with fourier transform infrared spectroscopy (FTIR), X-ray photoelectron spectroscopy (XPS) and transmission electron microscopy (TEM). Epoxy functionality was introduced onto the MFC surface by oxidation with cerium (IV) followed by grafting of glycidyl methacrylate. The length of the polymer chains could be varied by regulating the amount of glycidyl methacrylate added. Positive charge was introduced to the MFC surface through grafting of hexamethylene diisocyanate, followed by reaction with the amines. Succinic and maleic acid groups could be introduced directly onto the MFC surface as a monolayer by a reaction between the corresponding anhydrides and the surface hydroxyl groups of the MFC.

No abstract

No abstract