No abstract

No abstract

The use of fibers in Reinforced Concrete (RC) elements changes their cracking pattern, leading to narrower and more closely spaced cracks. In addition, the presence of fibers can improve the steel-to-concrete bond behavior reducing the steel-to-concrete interface damage after cracking. Cracks and steel-toconcrete interface damage work like paths, for aggressive agents, to reach the rebar in cracking elements, reducing the initiation period of the corrosion process, and favoring the corrosion at the intersection between cracks and reinforcement. In this context, this article discusses an experimental program on tension ties mechanically cracked and exposed to a chloride-rich environment with the purpose to check and eventually adequate the typical electrochemical measurements, used in the case of RC elements, for Steel Fiber Reinforced Concrete (SFRC). Adjustments related to degradation morphology and interference of steel fibers are proposed and used on Fiber Reinforced Concrete (FRC) elements for monitoring the influence of cracks and fibers on corrosion propagation. Finally, these proposed modifications were checked and validated against the results obtained by monitoring SFRC beams in the cracked stage.Discussion on this paper must be submitted within two months of the print publication. The discussion will then be published in print, along with the authors' closure, if any, approximately nine months after the print publication.

No abstract

The paper presents a synthesis of an extensive experimental campaign on linear and two‐dimensional steel fiber reinforced concrete (SFRC) structural elements carried out to check the ductility requirements aimed at guaranteeing limit analysis approaches for the computation of ultimate load‐bearing capacity of SFRC structures; special attention is devoted to the role of the degree of redundancy of the structure. In particular, full‐scale shallow beams and slabs reinforced with steel fibers (with or without conventional longitudinal reinforcement) were tested in two different laboratories: the Politecnico di Milano (PoliMI) and the University of Brescia (UniBS). In this experimental campaign, two different fiber contents and fiber types were considered. The experimental investigation, carried out within the activities to support Annex L of Eurocode 2, was fundamental also for developing the design rules included in the fib Model Code 2020 and allowed to formulate conclusions regarding optimization of the mix design, ductility, and design prediction at the ultimate capacity.