No abstract

A number of cases of respiratory sensitization to soluble platinum have arisen in the U.K. over the last few years, despite measured 8 h TWA exposure levels below the current long-term exposure limit in most cases. One possible cause of sensitization may be as a result of high exposures over short periods. Short-term sampling has been hampered by inadequate sampling and analysis techniques. This investigation has used two types of personal inhalable sampler, with ICPMS analysis, to take 15 min TWA soluble platinum exposure measurements at three sites. The lower detection limit for soluble platinum salts was approximately 0.01 microgram m-3 for 15 min samples, allowing exposures two orders of magnitude below the exposure limit to be measured. It was found that the majority of short-term exposure levels were significantly below 0.006 mg m-3. No evidence was found for altered work practices during sampling, indicating that either sensitization is occurring at airborne exposure levels below the exposure limit, or there is an alternate route of exposure.

No abstract

The new European chemicals legislation REACH (Registration, Evaluation, Authorisation and restriction of Chemicals) requires the development of Exposure Scenarios describing the conditions and risk management measures needed for the safe use of chemicals. Such Exposure Scenarios should integrate considerations of both human health and the environment. Specific aspects are relevant for worker exposure. Gathering information on the uses of the chemical is an important step in developing an Exposure Scenario. In-house information at manufacturers is an important source. Downstream users can contribute information through direct contact or through their associations. Relatively simple approaches (Tier 1 tools, such as the ECETOC Targeted Risk Assessment and the model EASE) can be used to develop broad Exposure Scenarios that cover many use situations. These approaches rely on the categorisation of just a few determinants, including only a small number of risk management measures. Such approaches have a limited discriminatory power and are rather conservative. When the hazard of the substance or the complexity of the exposure situation require a more in-depth approach, further development of the Exposure Scenarios with Tier 2 approaches is needed. Measured data sets of worker exposure are very valuable in a Tier 2 approach. Some downstream user associations have attempted to build Exposure Scenarios based on measured data sets. Generic Tier 2 tools for developing Exposure Scenarios do not exist yet. To enable efficient development of the worker exposure part of Exposure Scenarios a further development of Tier 1 and Tier 2 tools is needed. Special attention should be given to user friendliness and to the validity (boundaries) of the approaches. The development of standard worker exposure descriptions or full Exposure Scenarios by downstream user branches in cooperation with manufacturers and importers is recommended.

No abstract