Piezoelectric ceramics are currently of considerable interest for their capabilities of converting compressive/tensile stresses to an electric charge, or vice versa. Because ceramics cannot be cast and machined easily, additive manufacturing (AM) processes (3D printing technology) open an effective pathway in geometrical flexibility. However, the piezoelectric properties limit the application of printed ceramics. This work demonstrates that a piezoelectric-composite slurry with BaTiO 3 nanoparticles (100nm) can be 3D printed using Mask-Image-Projection-based Stereolithography (MIP-SL) technology. After a post-process, the density of 5.64g/cm 3 was obtained, which corresponds to 93.7% of the density of bulk BaTiO 3 (6.02 g/cm 3 ). The printed 1 Zeyu Chen and Xuan Song contribute equally to this paper 2 ceramic exhibits a piezoelectric constant and relative permittivity of 160 pCN -1 and 1350respectively. An ultrasonic transducer with printing focused piezoelectric element was fabricated to realize the energy focusing and ultrasonic sensing. A 6.28MHz ultrasonic scan was achieved by the transducer and successfully visualized the structure of a porcine eyeball.

No abstract

Acute coronary syndrome (ACS) is frequently associated with the sudden rupture of a vulnerable atherosclerotic plaque within the coronary artery. Several unique physiological features, including a thin fibrous cap accompanied by a necrotic lipid core, are the targeted indicators for identifying the vulnerable plaques. Intravascular ultrasound (IVUS), a catheter-based imaging technology, has been routinely performed in clinics for more than 20 years to describe the morphology of the coronary artery and guide percutaneous coronary interventions. However, conventional IVUS cannot facilitate the risk assessment of ACS because of its intrinsic limitations, such as insufficient resolution. Renovation of the IVUS technology is essentially needed to overcome the limitations and enhance the coronary artery characterization. In this paper, a multi-frequency intravascular ultrasound (IVUS) imaging system was developed by incorporating a higher frequency IVUS transducer (80 to 150 MHz) with the conventional IVUS (30–50 MHz) system. The newly developed system maintains the advantage of deeply penetrating imaging with the conventional IVUS, while offering an improved higher resolution image with IVUS at a higher frequency. The prototyped multi-frequency catheter has a clinically compatible size of 0.95 mm and a favorable capability of automated image co-registration. In vitro human coronary artery imaging has demonstrated the feasibility and superiority of the multi-frequency IVUS imaging system to deliver a more comprehensive visualization of the coronary artery. This ultrasonic-only intravascular imaging technique, based on a moderate refinement of the conventional IVUS system, is not only cost-effective from the perspective of manufacturing and clinical practice, but also holds the promise of future translation into clinical benefits.

No abstract

High resolution ultrasonic imaging requires high frequency wide band ultrasonic transducers, which produce short pulses and highly focused beam. However, currently the frequency of ultrasonic transducers is limited to below 100 MHz, mainly because of the challenge in precise control of fabrication parameters. This paper reports the design, fabrication, and characterization of sensitive broadband lithium niobate (LiNbO3) single element ultrasonic transducers in the range of 100–300 MHz, as well as their applications in high resolution imaging. All transducers were built for an f-number close to 1.0, which was achieved by press-focusing the piezoelectric layer into a spherical curvature. Characterization results demonstrated their high sensitivity and a −6 dB bandwidth greater than 40%. Resolutions better than 6.4 μm in the lateral direction and 6.2 μm in the axial direction were achieved by scanning a 4 μm tungsten wire target. Ultrasonic biomicroscopy images of zebrafish eyes were obtained with these transducers which demonstrate the feasibility of high resolution imaging with a performance comparable to optical resolution.