No abstract

The aim of this study was to investigate the physicochemical, biological, and handling properties of a new developed calcium phosphate (Ca-P) cement when implanted in trabecular bone. Ca-P cement consisting of a powder and a liquid phase was implanted as a paste into femoral trabecular bone of goats for 3 days and 2, 8, 16, and 24 weeks. The cement was tested using three clinically relevant liquid-to-powder ratios. Polymethylmethacrylate bone cement, routinely used in orthopedics, was used as a control. The Ca-P cement was easy to handle and was fast setting with good cohesion when in contact with body fluids. X-ray diffraction at the different implantation periods showed that the cement had set as an apatite and remained stable over time. Histological evaluation after 2 weeks, performed on 10 microm un-decalcified sections, showed abundant bone apposition on the cement surface without any inflammatory reaction or fibrous encapsulation. At later time points, the Ca-P cement implants were totally covered by a thin layer of bone. Osteoclast-like cells, as present at the interface, had resorbed parts of the cement mass. At locations where Ca-P cement was resorbed, new bone was formed without loss of integrity between the bone bed and the cement. This demonstrated the osteotransductive property of the cement, i.e., resorption of the material by osteoclast-like cells, directly followed by the formation of new bone. Histological and histomorphometrical evaluation did not show any significant differences between the Ca-P cement implanted at the three different liquid/powder ratios. The results indicate that the investigated Ca-P cement is biocompatible, osteoconductive, as well as osteotransductive and is a candidate material for use as a bone substitute.

We conducted an in vivo experiment to evaluate the resorption rate of a calcium phosphate cement (CPC) with macropores larger than 100 microm, using the CPC called Biocement D (Merck Biomaterial, Darmstadt, Germany), which after setting only shows pores smaller than 1 microm. The gas bubble method used during the setting process created macroporosity. Preset nonporous and porous cement implants were inserted into the trabecular bone of the tibial metaphysis of goats. The size of the preset implants was 6 mm and the diameter of the drill hole was 6.3 mm, leaving a gap of 0.3 mm between implant surface and drill wall. After 2 and 10 weeks, the animals were euthanized and cement implants with surrounding bone were retrieved for histologic evaluation. Light microscopy at 2 weeks revealed that the nonporous implants were surrounded by connective tissue. On the cement surface, we observed a monolayer of multinucleated cells. Ten weeks after implantation, the nonporous implants were still surrounded by connective tissue. However, a thin layer of bone now covered the implant surface. No sign of cement resorption was observed. In contrast, the porous cement evoked a completely different bone response. At 2 weeks, bone formation had already occurred inside the implant porosity. Bone formation even appeared to occur as a result of osteoinduction. Also, at their outer surface, the porous implants were completely surrounded by bone. At 2 weeks, about 31% of the initial cement was resorbed. After 10 weeks, 81% of the initial phosphate cement was resorbed and new bone was deposited. On the basis of these observations, we conclude that the creation of macropores can significantly improve the resorption rate of CPC. This increased degradation is associated with almost complete bone replacement.

No abstract

The aim of this study was to evaluate the clinical applicability and biological behavior of a newly developed injectable calcium phosphate (Ca-P) cement as bone filler for gaps around oral implants. Twenty-four step-like implants, creating gaps of 1 and 2 mm, were inserted into the trabecular bone of the medial femoral condyles of six goats. Four different situations were tested: (1) implant + gaps; (2) implant + gaps, but covered with a polylactic acid membrane; (3) implant + gaps that were filled with Ca-P cement; and (4) implant + gaps that were filled with Ca-P cement and covered with a membrane. All implants were left in place for 12 weeks. Histological and quantitative histomorphometrical measurements demonstrated that implants + gaps had generally poor bone contact at the implant base. Furthermore, fibrous encapsulation was observed in the gap part. In contrast, the presence of a membrane promoted bone ingrowth into the gap and also the bone contact at the implant base. Injection of Ca-P cement resulted in an almost complete filling of the gaps around the implant. The cement surface was completely covered by bone. Active resorption and remodeling of cement particles was observed, suggesting a pattern of slow resorption associated with full replacement with newly formed bone. Additional use of a membrane did not result in adjunctive benefits. Bone-to-implant contact at the implant base was comparable with the implants provided only with a membrane. In conclusion, the Ca-P cement used here showed excellent clinical handling properties combined with a superior bone behavior. On the other hand, the degradation rate of the material was still very slow. This current characteristic can hamper the final clinical applicability of the material as gap filler for periimplant or periodontal defects.