Improving the long-term stability of perovskite solar cells is critical to the deployment of this technology. Despite the great emphasis laid on stability-related investigations, publications lack consistency in experimental procedures and parameters reported. It is therefore challenging to reproduce and compare results and thereby develop a deep understanding of degradation mechanisms. Here, we report a consensus between researchers in the field on procedures for testing perovskite solar cell stability, which are based on the International Summit on Organic Photovoltaic Stability (ISOS) protocols. We propose additional procedures to account for properties specific to PSCs such as ion redistribution under electric fields, reversible degradation and to distinguish ambient-induced degradation from other stress factors. These protocols are not intended as a replacement of the existing qualification standards, but rather they aim to unify the stability assessment and to understand failure modes. Finally, we identify key procedural information which we suggest reporting in publications to improve reproducibility and enable large data set analysis.

No abstract

We report on accelerated degradation testing of MAPbX3 films (X = I or Br) by exposure to concentrated sunlight of 100 suns and show that the evolution of light absorption and the corresponding structural modifications are dependent on the type of halide ion and the exposure temperature. One hour of such exposure provides a photon dose equivalent to that of one sun exposure for 100 hours. The degradation in absorption of MAPbI3 films after exposure to 100 suns for 60 min at elevated sample temperature (∼45-55 °C), due to decomposition of the hybrid perovskite material, is documented. No degradation was observed after exposure to the same sunlight concentration but at a lower sample temperature (∼25 °C). No photobleaching or decomposition of MAPbBr3 films was observed after exposure to similar stress conditions (light intensity, dose, and temperatures). Our results indicate that the degradation is highly dependent on the hybrid perovskite composition and can be light- and thermally enhanced.

The temperature dependence of the principal photovoltaic parameters of perovskite photovoltaics is studied. The recombination activation energy is in good agreement with the perovskite's bandgap energy, thereby placing an upper bound on the open-circuit voltage. The photocurrent increases moderately with temperature and remains high at low temperature, reinforcing that the cells are not hindered by insufficient thermally activated mobility or carrier trapping by deep defects.

We report on the temperature dependence of various photovoltaic device parameters of solar cells, fabricated from interpenetrating networks of conjugated polymers with fullerenes, in the wide temperature range of their possible operating conditions (25–60 °C). The open-circuit voltage was found to decrease linearly with increasing temperature. For the short-circuit current, we observed a monotonic increase with increasing temperature, followed by a saturation region. The rate of this increase (coupled to a corresponding increase for the fill factor) was found to overtake the corresponding rate of decrease in voltage, resulting in an overall increase of the energy conversion efficiency. The efficiency was observed to reach a maximum value in the approximate range 47–60 °C. The results are discussed with respect to possible mechanisms for photovoltage generation and charge carrier transport in the conjugated polymer-fullerene composite, and in particular, thermally activated charge carrier mobility.