During cardiac resuscitation from ventricular fibrillation (VF) it would be helpful if we could monitor and predict the optimal state of the heart to be shocked into a perfusing rhythm. Real-time feedback of this state to the emergency medical staff (EMS) could improve the survival rate after resuscitation. In this paper, using real world out-of-the-hospital human VF data obtained during resuscitation by EMS personnel, we present the results of applying wavelet markers in predicting the shock outcomes. We also performed comparative analysis of 5 existing techniques (spectral and correlation based approaches) against the proposed wavelet markers. A database of 29 human VF tracings was extracted from the defibrillator recordings collected by the EMS personnel and was used to validate the waveform markers. The results obtained by the comparison of the wavelet based features with other spectral, and correlation-based features indicates that the proposed wavelet features perform well with an overall accuracy of 79.3% in predicting the shock outcomes and hence demonstrate potential to provide near real-time feedback to EMS personnel in optimizing resuscitation outcomes.

No abstract

No abstract

Abstract. Current density imaging (CDI) is a magnetic resonance (MR) imaging technique that could be used to study current pathways inside the tissue. The current distribution is measured indirectly as phase changes. The inherent noise in the MR imaging technique degrades the accuracy of phase measurements leading to imprecise current variations. The outcome can be affected significantly, especially at a low signal-to-noise ratio (SNR). We have shown the residual noise distribution of the phase to be Gaussian-like and the noise in CDI images approximated as a Gaussian. This finding matches experimental results. We further investigated this finding by performing comparative analysis with denoising techniques, using two CDI datasets with two different currents (20 and 45 mA). We found that the block-matching and three-dimensional (BM3D) technique outperforms other techniques when applied on current density (J). The minimum gain in noise power by BM3D applied to J compared with the next best technique in the analysis was found to be around 2 dB per pixel. We characterize the noise profile in CDI images and provide insights on the performance of different denoising techniques when applied at two different stages of current density reconstruction.

Spatial distribution of injected current in a subject could be calculated and visualized through current density imaging (CDI). Calculated CDI paths however have a limited degree of accuracy due to both avoidable methodological errors and inevitable limitations dictated by MR imaging constraints. The source and impact of these limitations are scrutinized in this paper. Quantification of such limitations is an essential step prior to passing any judgment about the results especially in biomedical applications. An innovative technique along with metrics for evaluation of range of errors using baseline and phase cycle MR images is proposed in this work. The presented approach is helpful in pinpointing the local artifacts (areas for which CDI results are suspect), evaluation of global noises and artifacts and assessment of the effect of approximation algorithms on real and artifactual components. We will demonstrate how this error/reliability evaluation is applicable to interpretation of CDI results and in this framework, report the CDI results for an artificial phantom and a live pig heart in Langendorff setup. It is contended here that using this method, the inevitable trade-off between details and approximations of CDI components could be monitored which provides a great opportunity for robust interpretation of results. The proposed approach could be extended, adapted and used for statistical analysis of similar methods which aim at mapping current and impedance based on magnetic flux images obtained through MRI.