No abstract

In the present study, reactive red 198 (RR198) dye removal from aqueous solutions by adsorption using municipal solid waste (MSW) compost ash was investigated in batch mode. SEM, XRF, XRD, and BET/BJH analyses were used to characterize MSW compost ash. CNHS and organic matter content analyses showed a low percentage of carbon and organic matter to be incorporated in MSW compost ash. The design of adsorption experiments was performed by Box–Behnken design (BBD), and process variables were modeled and optimized using Box–Behnken design-response surface methodology (BBD-RSM) and genetic algorithm-artificial neural network (GA-ANN). BBD-RSM approach disclosed that a quadratic polynomial model fitted well to the experimental data (F-value = 94.596 and R2 = 0.9436), and ANN suggested a three-layer model with test-R2 = 0.9832, the structure of 4-8-1, and learning algorithm type of Levenberg–Marquardt backpropagation. The same optimization results were suggested by BBD-RSM and GA-ANN approaches so that the optimum conditions for RR198 absorption was observed at pH = 3, operating time = 80 min, RR198 = 20 mg L−1 and MSW compost ash dosage = 2 g L−1. The adsorption behavior was appropriately described by Freundlich isotherm, pseudo-second-order kinetic model. Further, the data were found to be better described with the nonlinear when compared to the linear form of these equations. Also, the thermodynamic study revealed the spontaneous and exothermic nature of the adsorption process. In relation to the reuse, a 12.1% reduction in the adsorption efficiency was seen after five successive cycles. The present study showed that MSW compost ash as an economical, reusable, and efficient adsorbent would be desirable for application in the adsorption process to dye wastewater treatment, and both BBD-RSM and GA-ANN approaches are highly potential methods in adsorption modeling and optimization study of the adsorption process. The present work also provides preliminary information, which is helpful for developing the adsorption process on an industrial scale.

The need for fresh water is more than before by population growth, and industrial development have affected the quality of water supplies, one of the important reason for water contamination is synthetic dyes and their extensive use in industries. Adsorption has been considered as a common methods for dye removal from waters. In this study, Acid Red18 removal in batch mode by using Granular Ferric Hydroxide (GFH) was investigated. The GFH characterized by XRD, FESEM and FTIR analysis. Experiments were designed using RSM-CCD method. The maximum removal efficiency was obtained 78.59% at pH = 5, GFH dosage = 2 g/l, AR18 concentration = 77.5 mg/l and 85 min of contact time. Optimization with RSM and Genetic Algorithm carried out and is similar together. The non-linear adsorption Isotherm and kinetic fitted with Freundlich (R2 = 0.978) and pseudo-second-order (R2 = 0.989) models, respectively. Thermodynamic studies showed that the AR18 adsorption is endothermic process and GFH nature was found spontaneous.

Nitrate is a common contaminant of drinking water. Due to its adverse health effects, this study aimed to determine nitrate levels in six southern districts of Tehran. A total of 148 samples were taken from tap waters. In 84.46% (n = 125) of the samples, the nitrate concentration was below national and WHO limits (50 mg/L); however, 15.54% (n = 23) were in violation of the criteria. The total mean concentration of nitrate was 36.15 mg/L (±14.74) ranging from 4.52 to 80.83 mg/L. The overall hazard quotient (HQ) for age groups were ordered as Children (1.71) > Infants (1.24) > Teenagers (1.2) > Adults (0.96). In all districts, the HQ values for infants and children groups were greater than 1, indicating potential adverse health risks. In teenagers age group, only the HQ estimations of districts 10 (HQ = 0.93) and 11 (HQ = 0.74) were lower than 1 and in adults age group, the estimated HQ values for districts were lower than 1 with the exception for district 19 (HQ = 1.19). The sensitivity analysis (SA) showed that nitrate content plays a major role in the value of the assessed risk.

No abstract