No abstract

The application of barrier membranes in guided bone regeneration (GBR) has become a commonly used surgical technique in periodontal research. The objectives of this study were to evaluate the in vitro biocompatibility and osteogenic differentiation of mesenchymal stem cells (MSCs) on two different collagenous coatings (nano electrospun fibrous vs. solid wall) of bilayered collagen/chitosan membrane and their histological evaluation on bone regeneration in rabbit calvarial defects. It was found that chitosan-nano electrospun collagen (CNC) membranes had higher proliferation/metabolic activity compared to the chitosan-collagen (CC) and pristine chitosan membranes. The qRT-PCR analysis demonstrated the CNC membranes induced significant expression of osteogenic genes (Osteocalcin, RUNX2 and Col-α1) in MSCs. Moreover, higher calcium content and alkaline phosphatase activity of MSCs were observed compared to the other groups. Histologic and histomorphometric evaluations were performed on the uncovered (negative control) as well as covered calvarial defects of ten adult white rabbits with different membranes (CNC, CC, BioGide (BG, positive control)) at 1 and 2 months after surgery. More bone formation was detected in the defects covered with CNC and BG membranes than those covered by CC and the negative control. No inflammation and residual biomaterial particles were observed on the membrane surface or in the surrounding tissues in the surgical areas. These results suggest that bilayer CNC membrane can have the potential for use as a GBR membrane material facilitating bone formation.

Loading time does not seem to significantly affect the degree of osseointegration and bone-to-implant contact and the composition of newly formed bone around dental implants.

The tissue-engineered graft consisting of chitosan + fibroblast was applied to gingival augmentation procedures and generated keratinized tissue without any complications usually associated with donor-site surgery.

Introduction: Several techniques such as using citric acid, plastic curettes, ultrasonic devices, and lasers have been suggested for debridement of contaminated implant surfaces. This comparative investigation aimed to assess and compare the effects of Er, Cr: YSGG laser and super-saturated citric acid on the debridement of contaminated dental implant surfaces. Methods: In this in-vitro study, 12 contaminated failed implants were collected and randomly divided into 2 groups (6 in group A, and 6 in group B). Also, one implant was considered as the control. The implants were horizontally sectioned into coronal and apical portions and subsequently irradiated by Er, Cr: YSGG laser in coronal and citric acid in apical in group A and the opposite in group B. In order to evaluate the effect of water spray on the laser section, half the laser portion of the implants was irradiated using water, while the other half was irradiated without water with an irradiation time of 1 minute. Results: Results revealed that calculus and plaque removal was greater in the laser part of both groups (with and without water) compared to citric acid parts and the correlation between calculus removal and surface roughness were statistically significant. Furthermore, the surface roughness in the citric acid parts was significantly higher than in laser parts. Water spray during irradiation had a very small influence on understudy factors. Conclusion: Based on the results of this study, the Er, Cr: YSGG laser was more effective in calculus removal and caused less surface roughness compared with citric acid application.