The electrical properties of organic semiconductors (OSCs), whether they are conjugated small molecules or polymers, can be tailored by incorporating electrically insulating units (EIUs), which are organic moieties consisting of nonconjugated units. EIUs can be introduced to a thin film by synthetically connecting them to the otherwise conjugated OSC molecules or by blending them in as separate EIU molecules with the OSCs during the thin‐film fabrication process. The engineered EIUs are capable of imparting various additional functions to the OSC thin film and improving their electrical properties. In this review article, a comprehensive overview of various effects of EIUs on OSC thin films and their consequent electrical performance when used as active layers in organic field‐effect transistors (OFETs) is provided. A broad range of studies of the synthetic approaches of incorporating EIUs, such as those using side chains, block copolymers, and conjugation‐break spacers, and of the blending approaches with organic insulators is discussed. Finally, a brief summary and perspectives for future research in this field are presented.

One-step deposition of bi-functional semiconductor-dielectric layers for organic field-effect transistors (OFETs) is an effective way to simplify the device fabrication. However, the proposed method has rarely been reported in large-area flexible organic electronics. Herein, we demonstrate wafer-scale OFETs by bar coating the semiconducting and insulating polymer blend solution in one-step. The semiconducting polymer poly(3-hexylthiophene) (P3HT) segregates on top of the blend film, whereas dielectric polymethyl methacrylate (PMMA) acts as the bottom layer, which is achieved by a vertical phase separation structure. The morphology of blend film can be controlled by varying the concentration of P3HT and PMMA solutions. The wafer-scale one-step OFETs, with a continuous ultrathin P3HT film of 2.7 nm, exhibit high electrical reproducibility and uniformity. The one-step OFETs extend to substrate-free arrays that can be attached everywhere on varying substrates. In addition, because of the well-ordered molecular arrangement, the moderate charge transport pathway is formed, which resulted in stable OFETs under various organic solvent vapors and lights of different wavelengths. The results demonstrate that the one-step OFETs have promising potential in the field of large-area organic wearable electronics.

In this study, we designed and fabricated a high-performance humidity sensor based on a donor-acceptor polymer transistor. To improve its sensing performance, a polymeric semiconductor film with macroporous structure was prepared using a facilitated phase-separation method. The relationship between the sensing performance and the pore size was systematically investigated by testing the humidity-sensing performance. The results suggested that the sensitivity of the sensor was improved with increasing pore size within a certain range. The sensor based on the macroporous film with an average pore size of 154 nm exhibited a sensitivity of 415 and a response time of 0.68 s, as the low relative humidity (RH) changed from 32% RH (9146 ppm) to 69% RH (20 036 ppm). These sensitivity values are better than those obtained by other reported humidity sensors based on organic field-effect transistors.

A facile and controllable phase‐separation route using semiconductor/insulating polymer blends for the fabrication of a microporous semiconductor film is proposed. The microporous film‐based gas sensor exhibits excellent selectivity toward ammonia with a detection limit of 0.5 ppm, a high sensitivity of over 800 at 10 ppm NH3, and a response/recovery time of only a few seconds.

No abstract