No abstract

International audienceFieldwork complemented by SPOT image analysis throws light on current crustal shortening processes in the ranges of northeastern Tibet (Gansu and Qinghai provinces, China). The ongoing deformation of Late-Pleistocene bajada aprons in the forelands of the ranges involves folding, at various scales, and chiefly north-vergent, seismogenic thrusts. The most active thrusts usually break the ground many kilometres north of the range-fronts, along the northeast limbs of growing, asymmetric ramp-anticlines. Normal faulting at the apex of other growing anticlines, between the range fronts and the thrust breaks, implies slip on blind ramps connecting distinct active décollement levels that deepen southwards. The various patterns of uplift of the bajada surfaces can be used to constrain plausible links between contemporary thrusts downsection. Typically, the foreland thrusts and décollements appear to splay from master thrusts that plunge at least 15–20 km down beneath the high ranges. Plio-Quaternary anticlinal ridges rising to more than 3000 m a.s.l. expose Palaeozoic metamorphic basement in their core. In general, the geology and topography of the ranges and forelands imply that structural reliefs of the order of 5–10 km have accrued at rates of 1–2 mm yr−1 in approximately the last 5 Ma. From hill to range size, the elongated reliefs that result from such Late-Cenozoic, NE–SW shortening appear to follow a simple scaling law, with roughly constant length/width ratio, suggesting that they have grown self-similarly. The greatest mountain ranges, which are over 5.5 km high, tens of kilometres wide and hundreds of kilometres long may thus be interpreted to have formed as NW-trending ramp anticlines, at the scale of the middle–upper crust. The fairly regular, large-scale arrangement of those ranges, with parallel crests separated by piggy-back basins, the coevality of many parallel, south-dipping thrusts, and a change in the scaling ratio (from #5 to 8) for range widths greater than #30 km further suggests that they developed as a result of the northeastward migration of large thrust ramps above a broad décollement dipping SW at a shallow angle in the middle–lower crust. This, in turn, suggests that the 400–500 km-wide crustal wedge that forms the northeastern edge of the Tibet–Qinghai plateau shortens and thickens as a thickskinned accretionary prism decoupled from the stronger upper mantle underneath. Such a thickening process must have been coupled with propagation of the Altyn Tagh fault towards the ENE because most thrust traces merge northwestwards with active branches of this fault, after veering clockwise. This process appears to typify the manner in which the Tibet–Qinghai highlands have expanded their surface area in the Neogene. The present topography and structure imply that, during much of that period,

No abstract

Summary Field studies of active faulting in S Tibet indicate that Quaternary extension has been taking place at a rate of ≃1 cm yr −1 in a direction of ≃ 100°. This implies that underthrusting in the Himalayas now absorbs less than half of the total convergence between rigid India and Asia, the rest being taken up primarily by strike-slip faulting N of the collision belt. En échelon right-lateral, strike-slip faults in S Tibet now allow this corresponding eastward displacement of the plateau with respect to India. The reproducible pattern of faulting obtained from plane-strain indentation experiments on unilaterally confined blocks of plasticine suggests that this extrusion process has occurred during most of the collision history. The Tertiary geological record in SE Asia corroborates a polyphase extrusion model, with displacements in excess of 1000–1500 km, in which India has successively pushed Sundaland, then Tibet and S China towards the ESE. Most of the Middle Tertiary movements may have occurred along the then left-lateral Red River-Ailao Shan Fault Zone, together with the opening of most of the eastern S China Sea. Regional geology, stratigraphy and deformation observed in Yunnan are consistent with this inference, as well as the timing, geometry and rates of sea-floor spreading in the S China Sea. Fast spreading (5 cm yr −1 ) in that sea implies that the Tibetan highlands formed mostly after 17 Ma BP. Sideways movements can also account for the existence of large, conjugate but asymmetric, Tertiary strike-slip faults within Sundaland and the formation of Middle Tertiary pull-apart and rift basins on the Sunda Shelf. Changing directions of opening are predicted in the Mergui and Andaman Basins and the lowlands of Burma, as well as large right-lateral displacements along the Shan Scarp. Most of Sundaland probably lay initially in a frontal position with respect to impinging India and the Shan Plateau may have been a Middle Tertiary analogue of the present Tibetan Plateau. In contrast with dominant overthrusting in the Himalayas, Tertiary strike-slip faulting, with more subordinate folding and thrusting, appears to have been important along and N of the Zangbo Suture. This difference must be accounted for in all models of formation of the Tibet Plateau. The surface of the indentation mark, left by the impaction of India onto the presumably simpler Early Tertiary margin of Asia (> 6 million km 2 ), implies that mountain building and strike-slip faulting have absorbed, perhaps alternately, roughly equal amounts of collisional shortening. Since analogous interplays of extrusion and thickening probably govern the evolution of most collision zones, the Tertiary tectonics of Asia may be the best guide to unravel the interactions between Palaeozoic and Precambrian plates, for which sea-floor spreading constraints are unattainable.