SUMMARYThis paper proposes a novel single stage single switch resonant inverter with high power factor for electronic ballast. The power factor correction circuit is at the input side. It is designed to operate at discontinuous conduction mode. The lamp power is controlled by adjusting the duty ratio of the active switch of the power factor correction circuit. The circuit operation is analyzed in detail to derive the design equations. Circuit parameters are designed based on design considerations. Finally, prototype electronic ballast for a 40-W compact fluorescent lamp is built and tested. The efficiency and the performance of the proposed converter are verified for the designed prototype.

No abstract

In this paper, we report a novel single‐switch AC to DC step‐down converter suitable for light emitting diodes. The proposed topology has a buck and a buck–boost converter. The circuit is designed to operate in the discontinuous conduction mode in order to improve the power factor. In this topology, a part of the input power is connected to the load directly. This feature of the proposed topology increases the efficiency of power conversion, improves the input power factor, produces less voltage stress on intermediate stages, and reduces the output voltage in the absence of a step‐down transformer. The theoretical analysis, design procedure, and performance of the proposed converter are verified by simulation and experiment. A 36 V, 60 W prototype has been built to demonstrate the merits of this circuit. © 2017 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.

No abstract

A solar PV panel works with maximum efficiency only when it is operated around its optimum operating point or maximum power point. Unfortunately, the performance of the solar cell is affected by several factors like sun direction, solar irradiance, dust accumulation, module temperature, as well as the load on the system. Dust deposition is one of the most prominent factors that influence the performance of solar panels. Because the solar panel is exposed to the atmosphere, dust will accumulate on its surface, reducing the quantity of sunlight reaching the solar cell and diminishing output. In the proposed work, a detailed investigation of the performance of solar PV modules is carried out under the tropical climatic condition of Chennai, India, where the presence of dust particles is very high. The data corresponding to four different dust samples of various densities at four solar irradiation levels of 220, 525, 702, and 905 W/m 2 are collected, and performance analysis is carried out. Based on the analysis carried out, the maximum power loss is found to be 73.51%, 66.29%, 65.46%, and 61.42%, for coal, sand, brick powder, and chalk dust respectively. Hence, it can be said that coal dust contributes to the maximum power loss among all four dust samples. Due to heat dissipation produced by dust deposition, the performance of solar PV modules is degraded as the temperature rose.