CMOS‐compatible nonlinear optics platforms with negligible nonlinear losses and high nonlinearity are of great merit. Silicon, silicon nitride and Hydex glass have made significant headway in nonlinear optical signal processing, though none of these platforms possesses the highly sought after combination of high nonlinearity and negligible nonlinear losses. In this manuscript, we present a nonlinear optics platform based on silicon‐rich nitride, deposited at a low temperature of 250°C compatible with back‐end CMOS processing. The silicon‐rich nitride is designed and engineered in composition to have a bandgap of 2.05 eV, such that the two‐photon absorption edge is well below 1.55 μm. The designed and developed waveguides have a nonlinear parameter of 550 W−1/m, 500 times larger than that in silicon nitride waveguides, while at the same time not possessing two‐photon and free‐carrier losses. Using 500‐fs pulses, we generate supercontinuum exceeding 0.6 of an octave.

GeSbS ridge waveguides have recently been demonstrated as a promising mid – infrared platform for integrated waveguide – based chemical sensing and photodetection. To date, their nonlinear optical properties remain relatively unexplored. In this paper, we characterize the nonlinear optical properties of GeSbS glasses, and show negligible nonlinear losses at 1.55 μm. Using self – phase modulation experiments, we characterize a waveguide nonlinear parameter of 7 W−1/m and nonlinear refractive index of 3.71 × 10−18 m2/W. GeSbS waveguides are used to generate supercontinuum from 1280 nm to 2120 nm at the −30 dB level. The spectrum expands along the red shifted side of the spectrum faster than on the blue shifted side, facilitated by cascaded stimulated Raman scattering arising from the large Raman gain of chalcogenides. Fourier transform infrared spectroscopic measurements show that these glasses are optically transparent up to 25 μm, making them useful for short – wave to long – wave infrared applications in both linear and nonlinear optics.

Broadband Silicon-On-Insulator (SOI) directional couplers are designed based on a combination of curved and straight coupled waveguide sections. A design methodology based on the transfer matrix method (TMM) is used to determine the required coupler section lengths, radii, and waveguide cross-sections. A 50/50 power splitter with a measured bandwidth of 88 nm is designed and fabricated, with a device footprint of 20 μm × 3 μm. In addition, a balanced Mach-Zehnder interferometer is fabricated showing an extinction ratio of >16 dB over 100 nm of bandwidth.

The formation of optical solitons arises from the simultaneous presence of dispersive and nonlinear properties within a propagation medium. Chip-scale devices that support optical solitons harness high field confinement and flexibility in dispersion engineering for significantly smaller footprints and lower operating powers compared to fiber-based equivalents. High-order solitons evolve periodically as they propagate and experience a temporal narrowing at the start of each soliton period. This phenomenon allows strong temporal compression of optical pulses to be achieved. In this paper, soliton-effect temporal compression of optical pulses is demonstrated on a CMOS-compatible ultra-silicon-rich nitride (USRN) waveguide. We achieve 8.7× compression of 2 ps optical pulses using a low pulse energy of ∼16 pJ, representing the largest demonstrated compression on an integrated photonic waveguide to date. The strong temporal compression is confirmed by numerical calculations of the nonlinear Schrödinger equation to be attributed to the USRN waveguide’s large nonlinearity and negligible two-photon absorption at 1550 nm.

On-chip waveguide amplifiers offer higher gain in small device sizes and better integration with photonic devices than the commonly available fiber amplifiers. However, on-chip amplifiers have yet to make its way into the mainstream due to the limited availability of materials with ideal light guiding and amplification properties. A low-loss nanostructured on-chip channel polymeric waveguide amplifier was designed, characterized, fabricated and its gain experimentally measured at telecommunication wavelength. The active polymeric waveguide core comprises of NaYF4:Yb,Er,Ce core-shell nanocrystals dispersed within a SU8 polymer, where the nanoparticle interfacial characteristics were tailored using hydrolyzed polyhedral oligomeric silsesquioxane-graft-poly(methyl methacrylate) to improve particle dispersion. Both the enhanced IR emission intensity from our nanocrystals using a tri-dopant scheme and the reduced scattering losses from our excellent particle dispersion at a high solid loading of 6.0 vol% contributed to the outstanding optical performance of our polymeric waveguide. We achieved one of the highest reported gain of 6.6 dB/cm using a relatively low coupled pump power of 80 mW. These polymeric waveguide amplifiers offer greater promise for integrated optical circuits due to their processability and integration advantages which will play a key role in the emerging areas of flexible communication and optoelectronic devices.