A syntactic foam was prepared from an epoxy resin matrix and modified hollow glass microsphere fillers. Modification by silane coupling agents with different molecular structures was analyzed, and the optimal content of the silane coupling agent was determined. The results demonstrated that all silane coupling agents enhanced the adhesion between the hollow glass microspheres and epoxy resin matrix, resulting in enhanced water absorption, compressive performance, tensile performance, and bending performance compared to those prepared using unmodified hollow glass microspheres. Among silane coupling agents with different end groups, the one with a sulfhydryl end group exhibited optimal modification for hollow glass microspheres. Among the silane coupling agents with different backbone structures, the one with silanol groups exhibited the optimal modification of hollow glass microspheres. Additionally, the performance of the syntactic foams was optimal when 6% of the silanol-containing coupling agent was used. The results demonstrated that syntactic foams prepared with hollow glass microspheres modified by silane coupling agents exhibited improvements in water absorption, compressive performance, tensile performance, and bending performance, compared with those prepared using unmodified hollow glass microspheres. Among silane coupling agents with different end structures, the one with a sulfhydryl group as end group showed the best modification effect on hollow glass microspheres. The water absorption was 0.35%, the compressive strength was 62.15 MPa, the tensile strength was 40.15 MPa, and the bending strength was 53.17 MPa. Among silane coupling agents with different backbone structures, the one with silanol groupsbonds showed the best results. Its compressive strength was up to 64.15 MPa, the tensile strength was 35.47 MPa, and the bending strength was 53.99 MPa.

A novel epoxy resin (EP)/hollow glass microsphere modified (g-HGM) composite was successfully prepared. Studies showed that the water absorption rate of the g-HGMs/EP composite is lower than pure HGMs/EP and HGMs-KH550/EP composites, while the compressive strength of g-HGMs/EP composites could be increased. The enhanced interfacial adhesion between EP and g-HGMs played an important role to improve the compatibility of the two components. The g-HGMs show little effect on density (relative to HGMs) on the g-HGMs/EP composites, which can perform better than the HGMs/EP composites being used in marine environments. It was found that the optimal content of 4,4’-diphenylmethane diisocyanate in the epoxy component was 20 wt%.

Composite foams with 10–50 vol% hollow polymeric microspheres were prepared using bisphenol A epoxy resin and polyetheramine curing agent as the matrix. The results demonstrated that the density, hardness, and static mechanical properties of the epoxy resin/hollow polymer microsphere composite foams, as well as their dynamic mechanical properties under forced non-resonance, were similar to those of polymer/hollow glass microsphere composite foams. At 25°C and under 1–100 Hz forced resonance, the first-order and second-order resonance frequencies of the composite foams shifted to the low-frequency region as the volume fraction of hollow polymer microspheres increased. Meanwhile, the first-order and second-order loss factors of the as-prepared composite foams were improved by 41.7% and 103.3%, respectively, compared with the pure epoxy resin. Additionally, the first-order and second-order loss factors of the as-prepared composite foams reached a maximum at 40 vol% and 30 vol% hollow polymer microspheres, respectively. This research helps us to expand the application range of composite foam materials in damping research.