The thermally-induced fiber alignment shifts of fibersolder-ferrule (FSF) joints in laser module packaging have been studied experimentally and numerically. Direct measurements of the metallographic photos with and without temperature cycling, fiber displacement shifts of up to a 0.8 pm were found after undergoing 500 temperature cycles. Experimental results show that the fiber shifts increase as the temperature cycle number and the initial fiber eccentric offset increase. The major cause of fiber shift may come from the plastic solder yielding introduced by the thermal stress variation and the redistribution of the residual stresses during temperature cycling. A finite-element method (FEM) analysis was performed to evaluate the variation of thermal stresses, the distribution of residual stresses, and fiber shifts of the FSF joints. Experimental measurements were in reasonable agreement with the numerical calculations. Both results indicate that the initial offset introduced in the fiber soldering process is a key parameter in causing the thermally-induced fiber shift of FSF joints in laser module packaging. The fiber hft, and hence fiber alignment shift under temperature cycling tests can be reduced si@icantly if the fiber can be located close to the center of the ferrule.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.