in order to restrict the loss of material. Furthermore, due to their scalability and flexibility, 3D flexible electronics (see Supporting Information (SI), where Table S1 contains a list) were considered revolutionary materials and were used in many fields such as imperceptible electronic devices, wearable electronic devices, and bionic technology. [11][12][13] Recently studies have shown the encapsulation of sulfur in the pores of carbon materials, such as meso-/microporous carbons, [11] cable-shaped carbon, [12] and carbon nanotubes/fibers, [13] can reduce the capacity fading. However, such nonpolar flexible carbon materials have a destructive disadvantage; they only have physical van der Waals (vdW) adsorption for polar Li 2 S n , which leads to the facile detachment of Li 2 S n from the carbon surface. [14] This proves that carbon-based materials alone cannot serve as the perfect host. In light of this new insight, various types of polar functional groups on carbon-based materials have been demonstrated to increase the interaction between Li 2 S n species and the electrode; these materials can generally be categorized into three types: polymers (polyaniline, polypyrrole, poly(3,4ethylenedioxythiophene) (PEDOT)), [15] metal oxides

Self-powered flexible photodetectors without an external power source can meet the demands of next-generation portable and wearable nanodevices; however, the performance is far from satisfactory becuase of the limited match of flexible substrates and light-sensitive materials with proper energy levels. Herein, a novel self-powered flexible fiber-shaped photodetector based on double-twisted perovskite-TiO -carbon fiber and CuO-Cu O-Cu wire is designed and fabricated. The device shows an ultrahigh detectivity of 2.15 × 10 Jones under the illumination of 800 nm light at zero bias. CuO-Cu O electron block bilayer extends response range of perovskite from 850 to 1050 nm and suppresses dark current down to 10 A. The fast response speed of less than 200 ms is nearly invariable after dozens of cycles of bending at the extremely 90 bending angle, demonstrating excellent flexibility and bending stability. These parameters are comparable and even better than reported flexible and even rigid photodetectors. The present results suggest a promising strategy to design photodetectors with integrated function of self-power, flexibility, and broadband response.

Flexible perovskite photodetectors are usually constructed on indium-tin-oxide-coated polymer substrates, which are expensive, fragile, and not resistant to high temperature. Herein, for the first time, a high-performance flexible perovskite photodetector is fabricated based on low-cost carbon cloth via a facile solution processable strategy. In this device, perovskite microcrystal and Spiro-OMeTAD (hole transporting material) blended film act as active materials for light detection, and carbon cloth serves as both a flexible substrate and a conductive electrode. The as-fabricated photodetector shows a broad spectrum response from ultraviolet to near-infrared light, high responsivity, fast response speed, long-term stability, and self-powered capability. Flexible devices show negligible degradation after several tens of bending cycles and at the extremely bending angle of 180°. This work promises a new technique to construct flexible, high-performance photodetectors with low cost and self-powered capability.