One of the possible ways to challenge selenium (Se) and iodine (I) deficiency in human beings is the joint biofortification of plants with these elements. Though the relationship between Se and I is highly pronounced in mammals, little is known about their interactions in plants where Se and I are considered not to be essential. Peculiarities of Se and I assimilation by a natural Se accumulator, such as Brassica juncea L., cultivar Volnushka, were assessed upon joint and separate plant foliar supply with sodium selenate (50 mg Se L−1) and potassium iodide (100 mg I L−1), in two crop seasons (spring, summer). Conversely to the individual application of Se and I, their joint supply did not stimulate plant growth. Separate use of sodium selenate enhanced I accumulation by 2.64 times, while biofortification with I increased the Se content in plant leaves by 4.3 times; this phenomenon was also associated with significant increase of total soluble solids and ascorbic acid content in leaves. The joint supply of Se and I did not affect the mentioned parameters. Both joint and separate application of Se and I led to synergism between these elements in: inhibiting nitrate accumulation; stimulating flavonoids biosynthesis (2–2.3 times compared to control plants) as well as Al and B accumulation; decreasing Cd and Sr concentrations. Plant biofortification with I increased the content of Mn and decreased K and Li. The consumption of 100 g Brassica juncea leaves provided 100% of the adequate human requirement of Se and 15.5% of I.

The essentiality of selenium (Se) and iodine (I) to human beings and the widespread areas of selenium and iodine deficiency determine the high significance of functional food production with high levels of these elements. In this respect, joint biofortification of agricultural crops with Se and I is especially attractive. Nevertheless, in practice this topic has raised many problems connected with the possible utilization of many Se and I chemical forms, different doses and biofortification methods, and the existence of wide species and varietal differences. The limited reports relevant to this subject and the multiplicity of unsolved questions urge the need for an adequate evaluation of the results obtained up-to-date, useful for developing further future investigations. The present review discusses the outcome of joint plant Se–I biofortification, as well as factors affecting Se and I accumulation in plants, paying special attention to unsolved issues. A particular focus has been given to the prospects of herb sprouts production enriched with Se and I, as well as the interactions between the latter microelements and arbuscular-mycorrhizal fungi (AMF).

Production of functional food with high levels of selenium (Se) and iodine (I) obtained via plant biofortification shows significant difficulties due to the complex interaction between the two elements. Taking into account the known beneficial effect of silicon (Si) on plant growth and development, single and joint foliar biofortification of chervil plants with potassium iodide (150 mg L−1) and sodium selenate (10 mg L−1) was carried out in a pot experiment with and without Si nanoparticles foliar supplementation. Compared to control plants, nano-Si (14 mg L−1) increased shoot biomass in all treatments: by 4.8 times with Si; by 2.8 times with I + Si; by 5.6 times with Se + Si; by 4.0 times with I + Se + Si. The correspondent increases in root biomass were 4.5, 8.7, 13.3 and 10.0 times, respectively. The growth stimulation effect of Se, I and I + Se treatments resulted in a 2.7, 3.5 and 3.6 times increase for chervil shoots and 1.6, 3.1 and 8.6 times for roots, respectively. Nano-Si improved I biofortification levels by twice, while I and Se enhanced the plant content of each other. All treatments decreased nitrate levels, compared to control, and increased the photopigment accumulation. Improvement of total antioxidant activity and phenolic content was recorded only under the joint application of Se + I + Si. Foliar nano-Si treatment affected other element content in plants: decreased Na+ accumulation in single and joint supplementation with Se and I, restored Fe, Mn and Cr amount compared to the decreased levels recorded in separately Se and I fortified plants and promoted Al accumulation both with or without Se and I biofortification. The results of this research suggest high prospects of foliar nano-Si supply for enhancing both growth and joint I/Se biofortification of chervil.

The essentiality of selenium (Se) and iodine (I) for the human organism and the relationship between these two trace elements in mammal metabolism highlight the importance of the joint Se–I biofortification to vegetable crops in the frame of sustainable farming management. A research study was carried out in southern Italy to determine the effects of the combined inoculation with arbuscular mycorrhizal fungi (AMF) and biofortification with Se and I on plant growth, seed yield, quality, and antioxidant and elemental status, as well as residual biomass chemical composition of chickpea grown in two different planting times (14 January and 28 February). The AMF application improved the intensity of I and Se accumulation both in single and joint supply of these elements, resulting in higher seed yield and number as well as dry weight, and was also beneficial for increasing the content of antioxidants, protein, and macro- and microelements. Earlier planting time resulted in higher values of seed yield, as well as Se, I, N, P, Ca, protein, and antioxidant levels. Se and I showed a synergistic effect, stimulating the accumulation of each other in chickpea seeds. The AMF inoculation elicited a higher protein and cellulose synthesis, as well as glucose production in the residual biomass, compared to the single iodine application and the untreated control. From the present research, it can be inferred that the plant biostimulation through the soil inoculation with AMF and the biofortification with Se and I, applied singly or jointly, proved to be effective sustainable farming tools for improving the chickpea seed yield and/or quality, as well as the residual biomass chemical composition for energy production or beneficial metabolite extraction.

The complex evaluation of varietal biochemical differences in rhubarb juice, pomace and roots is highly useful to develop an efficient processing technology. Research was carried out to compare four rhubarb cultivars (Malakhit, Krupnochereshkovy, Upryamets and Zaryanka) in terms of the quality and antioxidant parameters of juice, pomace and roots. The laboratory analyses showed a high juice yield (75–82%) with a relatively high content of ascorbic acid (125–164 mg L−1) and other organic acids (16–21 g L−1). Citric, oxalic and succinic acids accounted for 98% of the total acids amount. The juice of the cultivar Upryamets demonstrated high levels of the natural preservatives sorbic (36.2 mg L−1) and benzoic acids (11.7 mg L−1), which are highly valuable in juice production. The juice pomace proved to be an excellent source of pectin and dietary fiber, whose concentrations reached 21–24% and 59–64%, respectively. The total antioxidant activity decreased according to the following sequence: root pulp (161–232 mg GAE g−1 d.w.) > root peel (115–170 mg GAE g−1 d.w.) > juice pomace (28.3–34.4 mg GAE g−1 d.w.) > juice (4.4–7.6 mg GAE g−1 f.w.), suggesting that root pulp is a highly valuable antioxidant source. The results of this research highlight the interesting prospects of the complex rhubarb plant processing for the production of juice, containing a wide spectrum of organic acids and natural stabilizers (sorbic and benzoic acids), dietary fiber and pectin (juice pomace) and natural antioxidants (roots).