A novel cathode material, carbon nanotube (CNT)-decorated NaV(PO) (NVP) microspheres, was designed and synthesized via spray-drying and carbothermal reduction methods. The microspheres were covered and embedded by CNTs, the surfaces of which were also covered by amorphous carbon layers. Thus, a carbon network composed of CNTs and amorphous carbon layers formed in the materials. The polarization of a 10 wt % CNT-decorated NVP (NVP/C10) electrode was much less compared with that of the electrode with pristine NVP without CNTs. The capacity of the NVP/C10 electrode only decreased from 103.2 to 76.2 mAh g when the current rates increased from 0.2 to 60 C. Even when cycled at a rate of 20 C, the initial discharge capacity of the NVP/C10 electrode was as high as 91.2 mAh g, and the discharge capacity was 76.9 mAh g after 150 cycles. The charge-transfer resistance and ohmic resistance became smaller because of CNT decorating. Meanwhile, the addition of CNTs can tune the size of the NVP particles and increase the contact area between NVP and the electrolyte. Consequently, the resulted NVP had a larger sodium ion diffusion coefficient than that of the pristine NVP.

No abstract

No abstract

SnS2 nanosheets/reduced graphene oxide (rGO) composite was prepared by reflux condensation and hydrothermal methods. In this composite, SnS2 nanosheets in-situ grew on the surface of rGO nanosheets. The SnS2/rGO composite as anode material was investigated both in lithium ion battery (LIB) and sodium ion battery (SIB) systems. The capacity of SnS2/rGO electrode in LIB achieved 514 mAh g−1 at 1.2 A g−1 after 300 cycles. Moreover, the SnS2/rGO electrode in SIB delivered a discharge capacity of 645 mAh g−1 at 0.05 A g−1; after 100 cycles at 0.25 A g−1, the capacity retention still keep 81.2% relative to the capacity of the 6th cycle. Due to the introduction of rGO in the composite, the charge-transfer resistance became much smaller. Compared with SnS2/C electrode, SnS2/rGO electrode had higher discharge capacity and much better cycling performance.

Reduced graphene oxide (rGO) sheet decorated Na3V2(PO4)3 (NVP) microspheres were successfully synthesized by spray-drying method. The NVP microspheres were embedded by rGO sheets, and the surface of the particles were coated by rGO sheets and amorphous carbon. Thus, the carbon conductive network consisted of rGO sheets and amorphous carbon generated in the cathode material. NVP microspheres decorated with different content of rGO (about 0, 4, 8, and 12 wt%) were investigated in this study. The electrochemical performance of NVP exhibited a significant enhancement after rGO introduction. The electrode containing about 8 wt% rGO (NVP/G8) showed the best rate and cycle performance. NVP/G8 electrode exhibited the discharge capacity of 64.0 mAh g−1 at 70°C, and achieved high capacity retention of 95.5% after cycling at 10°C for 100 cycles. The polarization of the electrode was inhibited by the introduction of rGO sheets. Meanwhile, compared with the pristine NVP electrode, NVP/G8 electrode exhibited small resistance and high diffusion coefficient of sodium ions.