It is designed a Fast Tool Servo (FTS) device which based on piezoelectric ceramic and jointed by flexible hinge. The flexible hinge has been analyzed and optimized both by the theoretical calculation and finite element analysis; and it has been physically manufactured and tested by means of pressure sensor and laser interferometer. The stiffness model was established. The driving voltage and displacement relationship has been revealed. The results indicate that this FTS system can reach a travel range for 60μm,the frequency response precedes 150Hz within 39μm travel range.

Spiral bevel gear is widely used in the automotive and aerospace manufacturing industries, and the machining process is complex and the material is difficult to cut. The characteristics of high hardness, strong chemical reactivity and poor heat dissipation make the machinability of 20CrMnTi poor for face-hobbing machining of spiral bevel gear. In the process of cutting, there are some problems such as severe tool wear, poor machining quality and low machining efficiency caused by higher cutting force and higher cutting temperature. Therefore, it is necessary to study and analyze the wear experiment of the cutting tools of spiral bevel gear for face-hobbing deeply. Firstly, under the single factor experimental conditions, the wear patterns of inside blade and outside blade are observed and analyzed at different rotational speeds, and the tool wear conditions are detected and measured analysis. Secondly, the tool wear morphology and element distribution of rake face and flank face of inside blade and outside blade are analyzed by scanning electron microscope and energy spectrometer, and the tool wear mechanism for face-hobbing of spiral bevel gear is discussed in depth. The results demonstrate that chipping and fracture are the main patterns of tool wear; the tool wear mechanism are mainly embodied in adhesive wear, diffusion wear and oxidation wear. The tool wear is mainly distributed on the main cutting edge, top edge and corner radius, and the top edge and corner radius are more seriously worn. The research results can provide an effective basis for exploring the tool wear mechanism and improving the tool life, and provide technical support for the design and development of gear machining tools.

No abstract

The optical structure has a large number of micro-structures, which has multiple arrays, complex free-form surface features. But those can not be achieved the requirements with traditional turning and grinding processing, it require to use high-frequency and micro-feed to get ultra-precision machining precision. After creating the 3D digital model of micro-displacement platform using Pro/Engineer, and analyzing the motion and the force, the paper studies the influencing factors about the rigidity and acceleration and explores the motion characteristics of the micro-displacement platform in the high-frequency control, and it the establishes the corresponding dynamics equation. The stiffness and linearity data is accessed after the micro-stage is simulated used by Admas and Ansys software. According to the above data, the structure of micro-stage is optimized in order to meet the ultra-precision machining accuracy and the quality of the workpiece. The research takes advantage of the favorable conditions of the Nanofabrication Laboratory, and it has completed the physical production of the micro-displacement platform supported by the introduction of innovative R&D team program of Guangdong Province, those provide a reliable experimental conditions for future in-depth study.

No abstract