The ANSYS-ICEPAK is used to establish and analyze the thermal condition of the cooling modular of the looped pulsating heat pipe in the street light, the reliability is proved by experimental results of thermal analysis. The experimental results show that: the temperature distributions on the surface of the lamp shell and loop heat pipe are uniform, and the average temperatures of them are about 40°Cand 43°C; while the maximum temperature of the chip base reaches 67.5°C. Through comparison, the simulation results are close to the actual measured results.

No abstract

No abstract

In this paper, coal-based reduction on flotation middling from iron ore containing carbonate at donganshan was studied, during which the effect of reduction temperature, reduction time, C/O mole ratio and feed layer thickness on reduction process were carried out. The results showed that the optimal reduction conditions required a temperature of 1250°C,a duration of 70min, a C/O mole ratio of 2.0 and a feed layer thickness of 25mm, and the iron powder containing 90.27% Fe with iron recovery of 93.36% was obtained after three stages low intensity magnetic separation, which could be used to make steel. According to the chemical analysis, most of the iron minerals were reduced to metallic iron. Coal-based reduction proved to be an alternative and promising process to conduct the fine particles and powders.

No abstract