The complex conductivity of soils remains poorly known despite the growing importance of this method in hydrogeophysics. In order to fill this gap of knowledge, we investigate the complex conductivity of 71 soils samples (including four peat samples) and one clean sand in the frequency range 0.1 Hz to 45 kHz. The soil samples are saturated with six different NaCl brines with conductivities (0.031, 0.53, 1.15, 5.7, 14.7, and 22 S m−1, NaCl, 25°C) in order to determine their intrinsic formation factor and surface conductivity. This data set is used to test the predictions of the dynamic Stern polarization model of porous media in terms of relationship between the quadrature conductivity and the surface conductivity. We also investigate the relationship between the normalized chargeability (the difference of in‐phase conductivity between two frequencies) and the quadrature conductivity at the geometric mean frequency. This data set confirms the relationships between the surface conductivity, the quadrature conductivity, and the normalized chargeability. The normalized chargeability depends linearly on the cation exchange capacity and specific surface area while the chargeability shows no dependence on these parameters. These new data and the dynamic Stern layer polarization model are observed to be mutually consistent. Traditionally, in hydrogeophysics, surface conductivity is neglected in the analysis of resistivity data. The relationships we have developed can be used in field conditions to avoid neglecting surface conductivity in the interpretation of DC resistivity tomograms. We also investigate the effects of temperature and saturation and, here again, the dynamic Stern layer predictions and the experimental observations are mutually consistent.

The fate of pesticides in aquifers is influenced by the small but not insignificant adsorption of pesticides to mineral surfaces. Batch experiments with five pesticides and four minerals were conducted to quantify the contributions to adsorption from different mineral surfaces and compare adsorption characteristics of selected pesticides. Investigated mineral phases included quartz, calcite, kaolinite, and alpha-alumina. Selected pesticides comprised atrazine (6-chloro-N2-ethyl-N4-isopropyl-1,3,5-triazine-2,4-diamine), isoproturon [3-(4-isopropylphenyl)-1,1-dimethylurea)], mecoprop [(RS)-2-(4-chloro-2-methylphenoxy)propionic acid], 2,4-D (2,4-dichlorophenoxyacetic acid), and bentazone [3-isopropyl-1H-2,1,3-benzothiadiazin-4-(3H)-one 2,2-dioxide]. Specific surface area and mineral surface charge proved to be important for the adsorption of these pesticides. Detectable adsorption of the anionic pesticides (mecoprop, 2,4-D, and bentazone) was only measured when positive sites were present on the mineral surface. However, when CaCl2 was added as an electrolyte, a detectable adsorption of mecoprop and 2,4-D was also measured on kaolinite (which exhibits a negative surface charge), probably due to formation of Ca-pesticide--surface complexes. Adsorption of the uncharged pesticides (atrazine and isoproturon) was detected only on kaolinite. The lack of adsorption on alpha-alumina indicates that the uncharged pesticides have a greater affinity for the silanol surface sites (=SiOH) than for the aluminol surface sites (=AlOH) in kaolinite. No measurable effect of ionic strength was found for the uncharged pesticides. The results indicate that quartz and calcite play a smaller role than clay minerals.

No abstract

No abstract

Iron oxides are important components influencing the adsorption of various inorganic and organic compounds in soils and sediments. In this study the adsorption on iron oxides of nonionic and ionic pesticides was determined as a function of solution pH, ionic strength, and pesticide concentration. The investigated iron oxides included two-line ferrihydrite, goethite, and lepidocrocite. Selected pesticides comprised atrazine (6-chloro-N2-ethyl-N4-isopropyl-1,3,5-triazine-2,4-diamine), isoproturon [3-(4-isopropylphenyl)-1,1-dimethylurea)], mecoprop [(RS)-2-(4-chloro-2-methylphenoxy)propionic acid], 2,4-D (2,4-dichlorophenoxyacetic acid), and bentazone [3-isopropyl-1H-2,1,3-benzothiadiazin-4(3H)-one 2,2-dioxide]. The adsorption of the nonionic pesticides (atrazine and isoproturon) was insignificant, whereas the adsorption of the acidic pesticides (mecoprop, 2,4-D, and bentazone) was significant on all investigated iron oxides. The adsorption capacity increased with decreasing pH, with maximum adsorption reached close to the pKa values. The addition of CaCl2 in concentrations from 0.0025 to 0.01 M caused the adsorption capacity to diminish. The adsorption of bentazone was significantly lower than the adsorption of mecoprop and 2,4-D, illustrating the importance of a carboxyl group in the pesticide structure. The adsorption capacity on the iron oxides increased in the order: lepidocrocite < goethite < two-line ferrihydrite. The maximum adsorption capacities of meco-prop and 2,4-D on goethite were found to be equivalent to the site density of singly coordinated hydroxyl groups on the faces of the dominant (110) form, suggesting that singly coordinated hydroxyl groups are responsible for adsorption. Differences in adsorption capacities between iron oxides can be explained by differences in the surface site density of singly coordinated hydroxyl groups. The maximum measured adsorption capacity of mecoprop on two-line ferrihydrite was equivalent to 0.2 mol/mol Fe.