Non-platinum group metal (non-PGM) oxygen reduction reaction (ORR) catalysts have been widely reported, but their application in proton exchange membrane fuel cells (PEMFCs) is challenging due to their poor performance in acidic environments. Here [BMIM][NTf2] ionic liquid (IL) modification of microporous ZnCoNC catalysts (derived from ZIF-ZnCo) is investigated to study their behavior in PEMFCs and to elucidate the catalytic mechanisms in practical operation. The high O2 solubility of ILs enhance the

Recent advances in developing high-performance anion exchange membranes (AEMs) for fuel cell (AEMFC) applications enable catalyst developers to investigate and test cheaper and/or more sustainable materials under operando fuel cell conditions. In this article, we integrate a high-performance Pd-CeO 2 /C hydrogen oxidation reaction (HOR) catalyst into AEMFCs in combination with different Pt and Pt-free cathodes. A H 2 / O 2 AEMFC peak power performance of 2 W cm −2 at 80 °C is obtained when using a Pt/C cathode (2 A cm −2 is achieved at a cell voltage of 0.6 V), which translates to 1 W cm −2 peak power density (0.7 A cm −2 is achieved at 0.6 V) at 60 °C with the switch to a cheap, critical raw material (CRM)-free Fe/C cathode catalyst.

In anion exchange membrane fuel cells, catalytic reactions occur at a well‐defined three‐phase interface, wherein conventional heterogeneous catalyst layer structures exacerbate problems, such as low catalyst utilization and limited mass transfer. We developed a structural engineering strategy to immobilize a molecular catalyst tetrakis(4‐methoxyphenyl)porphyrin cobalt(II) (TMPPCo) on the side chains of an ionomer (polyfluorene, PF) to obtain a composite material (PF‐TMPPCo), thereby achieving a homogeneous catalysis environment inside ion‐flow channels, with greatly improved mass transfer and turnover frequency as a result of 100 % utilization of the catalyst molecules. The unique structure of the homogeneous catalysis system comprising interconnected nanoreactors exhibits advantages of low overpotential and high fuel‐cell power density. This strategy of reshaping of the catalyst layer structure may serve as a new platform for applications of many molecular catalysts in fuel cells.

Anion-exchange membrane (AEM) fuel cells (AEMFCs) and water electrolyzers (AEMWEs) have gained strong attention of the scientific community as an alternative to expensive mainstream fuel cell and electrolysis technologies. However, in the high pH environment of the AEMFCs and AEMWEs, especially at low hydration levels, the molecular structure of most anion-conducting polymers breaks down because of the strong reactivity of the hydroxide anions with the quaternary ammonium (QA) cation functional groups that are commonly used in the AEMs and ionomers. Therefore, new highly stable QAs are needed to withstand the strong alkaline environment of these electrochemical devices. In this study, a series of isoindolinium salts with different substituents is prepared and investigated for their stability under dry alkaline conditions. We show that by modifying isoindolinium salts, steric effects could be added to change the degradation kinetics and impart significant improvement in the alkaline stability, reaching an order of magnitude improvement when all the aromatic positions are substituted. Density functional theory (DFT) calculations are provided in support of the high kinetic stability found in these substituted isoindolinium salts. This is the first time that this class of QAs has been investigated. We believe that these novel isoindolinium groups can be a good alternative in the chemical design of AEMs to overcome material stability challenges in advanced electrochemical systems.

In a prior paper [Bance-Soualhi et al., J. Mater. Chem. A, 2021, 9, 22025], we showed that the crosslinking of radiation-grafted anion-exchange membranes (RG-AEM) was necessary to obtain high enough...