The Young's modulus (E) and nanoindentation (NI) stressstrain curves of fully dense, transparent yttria were determined using a nano-indenter capable of continually measuring the stiffness (S). Two hemispherical indenters with radii of 1.4 and 5 lm were used, in addition to a Berkovich tip. The E values-calculated from the S vs. a (contact radius) curves obtained with both spherical indenters (158-171 GPa) were % 5% lower than the 176 GPa dynamic modulus measured on the same sample using ultrasound. Depending on range of penetration depths, the Berkovich modulus was % 1%-5% higher than the dynamic modulus. When the NI load-displacement curves were converted to NI stress-strain curves, the yield point obtained was 771 GPa. This value was % 20% and % 33% lower than the Vickers and Berkovich hardness values measured on the same sample, respectively. The Vickers microhardness values (8.870.2 GPa) and the fracture toughness extracted from the latter (1.570.3 MPa . m 1/2 ) are in good agreement with published results on samples with comparable microstructures. The strain hardening rates were almost identical for both tips; no tip size effect was observed. Based on this work, we conclude that S vs. a plots are a powerful, and relatively simple, technique to measure the Young's moduli of polycrystalline ceramics and other hard solids. The fact that one also obtains NI stress--strain curves is a distinct advantage over the more commonly used Berkovich tip.

No abstract

No abstract