In order to enhance microalgal growth in photobioreactors (PBRs), light requirement is one of the most important parameters to be addressed; light should indeed be provided at the appropriate intensity, duration, and wavelength. Excessive intensity may lead to photo-oxidation and -inhibition, whereas low light levels will become growth-limiting. The constraint of light saturation may be overcome via either of two approaches: increasing photosynthetic efficiency by genetic engineering, aimed at changing the chlorophyll antenna size; or increasing flux tolerance, via tailoring the photonic spectrum, coupled with its intensity and temporal characteristics. These approaches will allow an increased control over the illumination features, leading to maximization of microalgal biomass and metabolite productivity. This minireview briefly introduces the nature of light, and describes its harvesting and transformation by microalgae, as well as its metabolic effects under excessively low or high supply. Optimization of the photosynthetic efficiency is discussed under the two approaches referred to above; the selection of light sources, coupled with recent improvements in light handling by PBRs, are chronologically reviewed and critically compared.

Recent advances in devices and applications of high-birefringence fiber loop mirror sensors are addressed. In optical sensing, these devices may be used as strain and temperature sensors, in a separate or in a simultaneous measurement. Other described applications include: refractive index measurement, optical filters for interrogate gratings structures and chemical etching control. The paper analyses and compares different types of high-birefringence fiber loop mirror sensors using conventional and microstructured optical fibers. Some configurations are presented for simultaneous measurement of physical parameters when combined with others optical devices, for example with a long period grating.

The characteristics of the diffuse phase transition of Pb(Fe2/3W1/3)O3 relaxor ceramics doped with different amounts of Mn are investigated. The freezing temperature Tf, obtained by fitting the ω,Tmax to the Vogel–Fulcher relationship, clearly changes with the Mn content. It increases as the Mn content increases, approaching the Tmax(1 MHz) value of the relaxor curve. A concomitant decrease in the frequency dispersion of Tmax is also observed. The freezing temperature also increases as the 1:1 order of Fe3+ and W6+on B sites increases by air annealing but decreases by oxygen annealing. It is suggested that the Mn ions, which are predominantly compensated by oxygen vacancies, form with them defect pairs and that these pairs can couple to the spontaneous polarization vectors, increasing the correlation between the dipole moments and originating the increase of the freezing temperature. It is further suggested that filling up the oxygen vacancies by oxygen annealing will decrease the defect pairs and cause the opposite effect.

Ferroelectric materials with Bi-layered structure such as SrBi2Ta2O9 and SrBi2Nb2O9 are now intensively investigated in view of their applications in nonvolatile computer memories and high-temperature piezoelectric transducers. When Sr2+ is substituted with Ba2+, a significant disorder is induced and the material exhibits broadening of the phase transition. Such broadening is essential for applications since it allows achieving smooth temperature characteristics while maintaining high dielectric and piezoelectric properties. In this work, stoichiometric dense BaBi2Nb2O9 (BBN) ceramics are sintered using a mixed oxide route. Dielectric and ferroelectric properties are investigated in a broad range of temperatures and frequencies. Strong dispersion of the complex relative dielectric permittivity is observed including typical relaxor features such as shift of the permittivity maximum with frequency and broadening of the relaxation time spectrum with decreasing temperature. The dielectric relaxation obeys the Vögel–Fulcher relationship with anomalously low freezing temperature (Tf≈100 K), which is much lower than the permittivity maximum in the radio-frequency range. Polarization hysteresis loops testify linear properties of BBN at all temperatures above Tf. The properties of BBN ceramics are compared to conventional relaxor systems such as Pb(Mg, Nb)O3 and (Pb, La)(Zr, Ti)O3.