No abstract

Environmental pollution in Nigeria presents an urgent need to assess wastewater treatment facilities in various industries. This article presents an assessment of dissolved air flotation (DAF) operation in a dairy industry. The industry was visited, wastewater treatment facilities were assessed (based only on efficacy to remove selected environmental health-related pollutants) and measurements of essential design and characterization parameters were taken. The study revealed that the averages of flow rate, biochemical oxygen demand at 5 days (BOD 5 ), chemical oxygen demand (COD), suspended solids (SS) and total solids (TS) of the influent wastewater into the plant (DAF) were 3.45 L/s, 1652.37, 3304.67, 2333.82, and 4396.10 mg/L compared to effluent quality of 560. 37, 1127.33, 172.33, and 1866.67 mg/L for BOD 5 , COD, SS, and TS, respectively. The pH of the wastewater is being adjusted by addition of lime before the effluent equalization tank and individual efficacies of the system were 66. 09, 65.89, 65.89, 57.54, 8.68, and 94.49% for BOD 5 , COD, SS, TS, DS, and total nitrogen, respectively, with overall efficacy of 38.10%. It was concluded that failure (lower overall efficacy) of the system can be attributed to setting of lime in the oversized equalization tank (50 m 3 instead of 16.82 m 3 per 8 h shift), the lack of application of standardized engineering code and practices (provision of underground tank in the process, lack of complete coagulation processes, coagulation and flocculation units), lack of adequate aeration unit and lack of reliable systems for automatically adjusting dosage of coagulant and flocculant. Although, DAF unit is the centerpiece of a DAF-based system design, there are several other supporting systems important to optimal DAF operation. These observations, coupled with the analysis in this report, demonstrate that the facilities necessary to minimize continuous environmental pollution are lacking. Pollution will become an increasing problem unless pollution preventing codes and standards are developed; incorporated into government regulations and the regulations are enforced.

No abstract

No abstract

Soil contamination resulting from petroleum hydrocarbon contaminants poses a fairly substantial hazard to human health and the environment. Phytoremediation, land farming, and chemico–biological stabilization were used to treat total petroleum hydrocarbons (TPHs) and polycyclic aromatic hydrocarbons (PAHs) at a crude oil polluted soil site in Nigeria. A field pilot study was conducted by preparing nine cells with subcells attached to each serving as a control with an overall area of 1.53 m2. A complete block design method was used for the study. The prepared soil sample cells were divided into three groups with each group having approximately 300 kg of soil and delineated as low, medium, and high test plots. The low samples were spiked with 6.1 kg of crude oil, the medium samples were spiked with 12.2 kg of crudeoil, and the high samples were spiked with 18.3 kg of crude oil. Each row containing three cells with low, medium, and high concentrations were treated separately using the three treatment methods. The ratio of the soil sample to the organic amendment for the treatments was 2:1. The results showed over 90% degradation in the initial concentration of TPH and PAHs across different contaminant levels except in the control subcells where only 30% of degradation was recorded. Multivariate analysis of variance was employed to assess the significant difference in each treatment group while inferential statistics using a mean performance plot was used to ascertain the optimum treatment method. Land farming, chemico–biological stabilization, and phytoremediation ranked 1, 2, and 3, respectively. In conclusion, the three treatment methods employed all degraded the contaminants (TPH and PAHs) with land farming emerging as the best method.