High-availability seamless redundancy (HSR) is a redundancy protocol for Ethernet networks that provides two frame copies for each frame sent. Each copy will pass through separate physical paths, pursuing zero fault recovery time. This means that even in the case of a node or a link failure, there is no stoppage of network operations whatsoever. HSR is a potential candidate for the communications of a smart grid, but its main drawback is the unnecessary traffic created due to the duplicated copies of each sent frame, which are generated and circulated inside the network. This downside will degrade network performance and might cause network congestion or even stoppage. In this paper, we present two approaches to solve the above-mentioned problem. The first approach is called quick removing (QR), and is suited to ring or connected ring topologies. The idea is to remove the duplicated frame copies from the network when all the nodes have received one copy of the sent frame and begin to receive the second copy. Therefore, the forwarding of those frame copies until they reach the source node, as occurs in standard HSR, is not needed in QR. Our example shows a traffic reduction of 37.5% compared to the standard HSR protocol. The second approach is called the virtual ring (VRing), which divides any closed-loop HSR network into several VRings. Each VRing will circulate the traffic of a corresponding group of nodes within it. Therefore, the traffic in that group will not affect any of the other network links or nodes, which results in an enhancement of traffic performance. For our sample network, the VRing approach shows a network traffic reduction in the range of 67.7 to 48.4% in a healthy network case and 89.7 to 44.8% in a faulty network case, compared to standard HSR.

No abstract

Fault tolerance has long been a major concern for sensor communications in fault-tolerant cyber physical systems (CPSs). Network failure problems often occur in wireless sensor networks (WSNs) due to various factors such as the insufficient power of sensor nodes, the dislocation of sensor nodes, the unstable state of wireless links, and unpredictable environmental interference. Fault tolerance is thus one of the key requirements for data communications in WSN applications. This paper proposes a novel path redundancy-based algorithm, called dual separate paths (DSP), that provides fault-tolerant communication with the improvement of the network traffic performance for WSN applications, such as fault-tolerant CPSs. The proposed DSP algorithm establishes two separate paths between a source and a destination in a network based on the network topology information. These paths are node-disjoint paths and have optimal path distances. Unicast frames are delivered from the source to the destination in the network through the dual paths, providing fault-tolerant communication and reducing redundant unicast traffic for the network. The DSP algorithm can be applied to wired and wireless networks, such as WSNs, to provide seamless fault-tolerant communication for mission-critical and life-critical applications such as fault-tolerant CPSs. The analyzed and simulated results show that the DSP-based approach not only provides fault-tolerant communication, but also improves network traffic performance. For the case study in this paper, when the DSP algorithm was applied to high-availability seamless redundancy (HSR) networks, the proposed DSP-based approach reduced the network traffic by 80% to 88% compared with the standard HSR protocol, thus improving network traffic performance.

High-availability seamless redundancy (HSR) is a protocol for Ethernet networks that provides duplicated frames with zero recovery time in the event of any network component's failure. It is suited for applications that demand high availability and a very short time-outs such as substation automation systems (SAS). However, HSR generates excessive unnecessary unicast frames and spreads them throughout connected-ring networks, whether or not the destination node exists in network's rings. This unnecessary redundant traffic causes high bandwidth consumption, resulting in degradation of network performance. In this paper, we introduce a novel approach for filtering and reducing HSR unicast traffic in connected-ring networks, called "filtering HSR traffic" (FHT). The purpose of FHT is to filter HSR unicast traffic and remove circulated traffic for all rings in connected-ring networks. Therefore, FHT significantly reduces network unicast traffic in connected-ring networks. The traffic performance of FHT has been analyzed, evaluated, and compared to that of standard HSR protocol and the port locking (PL) approach. Various simulations were conducted to validate the traffic performance analysis. Analytical and simulation results showed that, for our sample network, FHT reduced network unicast traffic by about 82% compared with standard HSR and by about 56% compared with the PL approach, thus freeing up network bandwidth and improving network traffic performance.

Abstract:In this paper, we propose a very effectively filtering approach (EFA) to enhance network traffic performance for high-availability seamless redundancy (HSR) protocol in smart grids. The EFA combines a novel filtering technique for QuadBox rings (FQR) with two existing filtering techniques, including quick removing (QR) and port locking (PL), to effectively reduce redundant unicast traffic within HSR networks. The EFA filters unicast traffic for both unused terminal rings by using the PL technique and unused QuadBox rings based on the newly-proposed FQR technique. In addition, by using the QR technique, the EFA prevents the unicast frames from being duplicated and circulated in rings; the EFA thus significantly reduces redundant unicast traffic in HSR networks compared with the standard HSR protocol and existing traffic filtering techniques. The EFA also reduces control overhead compared with the filtering HSR traffic (FHT) technique. In this study, the performance of EFA was analyzed, evaluated, and compared to that of the standard HSR protocol and existing techniques, and various simulations were conducted to validate the performance analysis. The analytical and simulation results showed that for the sample networks, the proposed EFA reduced network unicast traffic by 80% compared with the standard HSR protocol and by 26-62% compared with existing techniques. The proposed EFA also reduced control overhead by up to 90% compared with the FHT, thus decreasing control overhead, freeing up network bandwidth, and improving network traffic performance.