We have developed quantitative and spatially resolved imaging techniques to identify the origin of nonradiative-radiative recombination and carrier transport losses in perovskite solar cells, offering potential for future real-time tracking of the lab-scaled devices and fast assessment of screening the large-area modules. By dual-chloride passivation strategy, the resulting 25.49 cm 2 perovskite solar module achieves a certified power conversion efficiency of 17.88%.

No abstract

Major challenges for InGaAs/GaAsP multiple quantum well (MQW) solar cells include both the difficulty in designing suitable structures and, because of the strain-balancing requirement, growing high-quality crystals. The present paper proposes a comprehensive design principle for MQWs that overcomes the trade-off between light absorption and carrier transport that is based, in particular, on a systematical investigation of GaAsP barrier effects on carrier dynamics that occur for various barrier widths and heights. The fundamental strategies related to structure optimization are as follows: (i) acknowledging that InGaAs wells should be thinner and deeper for a given bandgap to achieve both a higher absorption coefficient for 1e-1hh transitions and a lower compressive strain accumulation; (ii) understanding that GaAs interlayers with thicknesses of just a few nanometers effectively extend the absorption edge without additional compressive strain and suppress lattice relaxation during growth; and (iii) understanding that GaAsP barriers should be thinner than 3 nm to facilitate tunneling transport and that their phosphorus content should be minimized while avoiding detrimental lattice relaxation. After structural optimization of 1.23-eV bandgap quantum wells, a cell with 100-period In 0.30 GaAs(3.5 nm)/GaAs(2.7 nm)/GaAsP 0.40 (3.0 nm) MQWs exhibited significantly improved performance, showing 16.2% AM 1.5 efficiency without an anti-reflection coating, and a 70% internal quantum efficiency beyond the GaAs band edge. When compared with the GaAs control cell, the optimized cell showed an absolute enhancement in AM 1.5 efficiency, and 1.22 times higher efficiency with 38% current enhancement with an AM 1.5 cut-off using a 665-nm long-pass filter, thus indicating the strong potential of MQW cells in Ge-based 3-J tandem devices.

Bandgap engineering of strain-balanced InGaAs/GaAsP multiple quantum wells (MQWs) allows high-quality materials with an absorption edge beyond GaAs to be epitaxially grown in Ge/GaAs-based multijunction solar cells. We demonstrate MQW solar cells with effective bandgaps ranging from 1.31 eV to as low as 1.15 eV. The bandgap-voltage-offset of MQWs is found to be independent of effective bandgaps and superior to a bulk reference by approximately 0.1 V. This implies the merit of high photovoltage as compared with bulk cells with the same bandgap in addition to their widely bandgap-tunable property. Towards the realization of fully lattice-matched quad-junction devices, we demonstrate a 70-period, 1.15-eV bandgap MQW cell as a promising material in 0.66/1.15/1.51/1.99-eV quad-junction cells, whose practical efficiency has a potential to achieve over 50%. With such a large period number of MQWs, the reverse-biased external quantum efficiency reaches an average of over 60% in the spectral region corresponding to a 1.15-eV subcell; this is achieved with only a-few-percent drop at short-circuit condition. The device presented here reaches the target open-circuit voltage and over 75% of the current density required for realizing a 1.15-eV subcell in a 50%-efficient quad-junction solar cell. We believe that future devices which exploit light-trapping structures and enhanced carrier extraction will be able to reach the desired target.

No abstract