Listeria monocytogenes has the ability to form biofilms on food-processing surfaces, potentially leading to food product contamination. The objective of this research was to standardize a polyvinyl chloride (PVC) microtiter plate assay to compare the ability of L. monocytogenes strains to form biofilms. A total of 31 coded L. monocytogenes strains were grown in defined medium (modified Welshimer's broth) at 32°C for 20 and 40 h in PVC microtiter plate wells. Biofilm formation was indirectly assessed by staining with 1% crystal violet and measuring crystal violet absorbance, using destaining solution. Cellular growth rates and final cell densities did not correlate with biofilm formation, indicating that differences in biofilm formation under the same environmental conditions were not due to growth rate differences. The mean biofilm production of lineage I strains was significantly greater than that observed for lineage II and lineage III strains. The results from the standardized microtiter plate biofilm assay were also compared to biofilm formation on PVC and stainless steel as assayed by quantitative epifluorescence microscopy. Results showed similar trends for the microscopic and microtiter plate assays, indicating that the PVC microtiter plate assay can be used as a rapid, simple method to screen for differences in biofilm production between strains or growth conditions prior to performing labor-intensive microscopic analyses.

Thyme oil-in-water nanoemulsions (pH 3.5) were prepared as potential antimicrobial delivery systems. The nanoemulsions were highly unstable to droplet growth and phase separation, which was attributed to Ostwald ripening due to the relatively high water solubility of thyme oil. Ostwald ripening could be inhibited by mixing thyme oil with a water-insoluble ripening inhibitor (≥60 wt % corn oil or ≥50 wt % MCT in the lipid phase) before homogenization, yielding nanoemulsions with good physical stability. Physically stable thyme oil nanoemulsions were examined for their antimicrobial activities against an acid-resistant spoilage yeast, Zygosaccharomyces bailii (ZB). Oil phase composition (ripening inhibitor type and concentration) had an appreciable influence on the antimicrobial activity of the thyme oil nanoemulsions. In general, increasing the ripening inhibitor levels in the lipid phase reduced the antimicrobial efficacy of nanoemulsions. For example, for nanoemulsions containing 60 wt % corn oil in the lipid phase, the minimum inhibitory concentration (MIC) of thyme oil to inhibit ZB growth was 375 μg/mL, while for nanoemulsions containing 90 wt % corn oil in the lipid phase, even 6000 μg/mL thyme oil could not inhibit ZB growth. This effect is also dependent on ripening inhibitor types: at the same concentration in the lipid phase, MCT decreased the antimicrobial efficacy of thyme oil more than corn oil. For instance, when the level of ripening inhibitor in the lipid phase was 70 wt %, the MICs of thyme oil for nanoemulsions containing corn oil and MCT were 750 and 3000 μg/mL, respectively. The results of this study have important implications for the design and utilization of nanoemulsions as antimicrobial delivery systems in the food and other industries.

Thyme oil-in-water nanoemulsions stabilized by a nonionic surfactant (Tween 80, T80) were prepared as potential antimicrobial delivery systems (pH 4). The nanoemulsions were highly unstable to droplet growth and phase separation, which was attributed to Ostwald ripening due to the relatively high water solubility of thyme oil. Ostwald ripening could be inhibited by incorporating ≥75% of corn oil (a hydrophobic material with a low water solubility) into the nanoemulsion droplets. The electrical characteristics of the droplets in the nanoemulsions were varied by incorporating ionic surfactants with different charges after homogenization: a cationic surfactant (lauric arginate, LAE) or an anionic surfactant (sodium dodecyl sulfate, SDS). The antifungal activity of nanoemulsions containing positive, negative, or neutral thymol droplets was then conducted against four strains of acid-resistant spoilage yeasts: Zygosaccharomyces bailli, Saccharomyces cerevisiae, Brettanomyces bruxellensis, and Brettanomyces naardenensis. The antifungal properties of the three surfactants (T80, LAE, SDS) were also tested in the absence of thymol droplets. Both ionic surfactants showed strong antifungal activity in the absence of thymol droplets, but no antimicrobial activity in their presence. This effect was attributed to partitioning of the antimicrobial surfactant molecules between the oil droplet and microbial surfaces, thereby reducing the effective concentration of active surfactants available to act as antimicrobials. This study shows oil droplets may decrease the efficacy of surfactant-based antimicrobials, which has important consequences for formulating effective antimicrobial agents for utilization in emulsion-based food and beverage products.

No abstract

Group A streptococcal C5a peptidase (SCPA) specifically cleaves the human serum chemotaxin C5a at the polymorphonuclear leukocyte (PMNL) binding site. This study tested the proposal that SCPA contributes to virulence by retarding the influx of inflammatory cells and clearance of streptococci during the first few hours after infection. To investigate the specific contribution of SCPA to the virulence of group A streptococci, scpA insertion and deletion mutants were created by directed plasmid insertion into scpA and gene replacement. The precise locations of insertion and deletion mutations were confirmed by PCR and DNA sequence analysis. The impact of mutation on virulence was investigated with a mouse air sac model of inflammation. Experiments evaluated clearance of streptococci from the air sac within 4 h after infection. SCPA ؊ streptococci were cleared more efficiently than wild-type bacteria. Localization of streptococci in lymph nodes and spleens of infected mice revealed a significant difference between mutant and wild-type streptococci. PMNLs and other granulocytes that infiltrated the air sac were quantitated by single-color flow cytometry. The total cellular infiltrate was greater and PMNLs dominated the granulocytic infiltrates of air sacs inoculated with SCPA ؊ mutant bacteria. The data obtained are consistent with the possibility that SCPA ؊ streptococci are initially cleared from the site of infection primarily by PMNLs. Moreover, mutant and wild-type streptococci followed different paths of dissemination. SCPA ؊ bacteria were transported to lymph nodes, whereas wild-type streptococci avoided transport to the lymph nodes and rapidly spread to the spleen.