No abstract

Aquaculture wastewater contains a huge amount of substances that can cause environmental pollution. However, microalgae can absorb these compounds and convert them into useful biomass. In this study, Chlorella minutissima was grown in the wastewater resulting from saline aquaculture. The microalgae were found to effectively utilize nitrogen and phosphorus in the wastewater for its growth. During wastewater treatment, the cell density increased almost fivefold compared to the initial value (OD 680 0.502). Moreover, batch culture resulted in the maximum biomass concentration and productivity of 4.77 g/L and 0.55 g/L/day, respectively. The contents of total nitrogen and total phosphorus in wastewater decreased by 88% and over 99%, respectively. In addition, the content of N-NO 3 was reduced by 88.6%, N-NO 2 by 74.3%, and dissolved orthophosphates (V) by 99%. At the beginning and throughout the experiment, the content of N-NH 4 in wastewater remained below 0.05 mg/L. Furthermore, a high lipid content of 46.4% (w/w) was also obtained from the studied microalgae.

Microalgal biomass and its cellular components are used as substrates for the production of fuels. A valuable group among the components of microalgal biomass is lipids, which act as a precursor for the production of biodiesel in the transesterification process. Some methods, including the creation of stressful conditions, are applied to increase the accumulation of lipids. This study aimed to determine the effect of limited nutrient access on the growth and development of the microalga Chlorella vulgaris and the amount of lipids stored in its cells. Aquaculture wastewater (AWW) was used in the study as a source of nutrients at doses of 20%, 40%, 60%, 80% and 100%. The amount of microalgal biomass, optical density, lipid content after extraction of the biomass in Soxhlet apparatus and chlorophyll a content were determined. It was observed that the microalgae efficiently used the nutrients contained in the AWW. The largest amount of biomass was obtained in AWW80 (727 ± 19.64 mg·L−1). The OD680 (0.492 ± 0.00) determined under the same conditions was almost five times higher in AWW than in the synthetic medium. Under nutrient-stress conditions, the content of lipids in biomass ranged from 5.75% (AWW80) to 11.81% (AWW20). The highest content of chlorophyll a in microalgal cells was obtained in AWW20 (206 ± 11.33 mg∙m−3).

Microalgae are a renewable source of unconventional biomass with potential application in the production of various biofuels. The production of carbon-neutral fuels is necessary for protecting the environment. This work determined the possibility of producing biomass of microalgae belonging to Monoraphidium genus using saline wastewater resulting from proecological salmon farming in the recirculating aquaculture system. The tests were carried out in tubular photobioreactors using LED light. As a part of the analyses, the growth and productivity of microalgal biomass, cell density in culture, and lipid concentration and ash content in biomass were determined. In addition, the concentration of selected phosphorus and nitrogen forms present in wastewater corresponding to the degree of their use by microalgae as a nutrient substrate was determined. The biomass concentration estimated in the tests was 3.79 g·L−1, while the maximum biomass productivity was 0.46 g·L−1·d−1. The cells’ optical density in culture measured at 680 nm was 0.648. The lipid content in biomass was 18.53% (dry basis), and the ash content was 32.34%. It was found that microalgae of the genus Monoraphidium effectively used the nitrogen as well as phosphorus forms present in the wastewater for their growth. The total nitrogen content in the sewage decreased by 82.62%, and total phosphorus content by over 99%. The analysis of the individual forms of nitrogen showed that N-NO3 was reduced by 85.37% and N-NO2 by 78.43%, while orthophosphate (V) dissolved in water was reduced by 99%. However, the content of N-NH4 in wastewater from the beginning till the end of the experiment remained <0.05 mg·L−1.

Biomass of microalgae and the components contained in their cells can be used for the production of heat, electricity, and biofuels. The aim of the presented study was to determine the optimal conditions that will be the most favorable for the production of large amounts of microalgae biomass intended for energy purposes. The study analyzed the effect of the type of lighting, the time of lighting culture, and the pH of the culture medium on the growth of Chlorella vulgaris biomass. The experiment was carried out in vertical tube photobioreactors in three photoperiods: 12/12, 18/6, and 24/0 h (light/dark). Two types of lighting were used in the work: high-pressure sodium light and light-emitting diode. The increase in biomass was determined by the gravimetric method, by the spectrophotometric method on the basis of chlorophyll a contained in the microalgae cells. The number of microalgae cells was also determined with the use of a hemocytometer. The optimal conditions for the production of biomass were recorded at a neutral pH, illuminating the cultures for 18 h a day. The obtained results were 546 ± 7.88 mg·L−1 dry weight under sodium lighting and 543 ± 1.92 mg·L−1 dry weight under light-emitting diode, with maximum biomass productivity of 27.08 ± 7.80 and 25.00 ± 5.1 mg·L−1∙d−1, respectively. The maximum content of chlorophyll a in cells was determined in the 12/12 h cycle and pH 6 (136 ± 14.13 mg∙m−3) under light-emitting diode and 18/6 h, pH 7 (135 ± 6.17 mg∙m−3) under sodium light, with maximum productivity of 26.34 ± 2.01 mg·m−3∙d−1 (light-emitting diode) and 24.21 ± 8.89 mg·m−3∙d−1 (sodium light). The largest number of microalgae cells (2.1 × 106) was obtained at pH 7 and photoperiod of 18/6 h under sodium light, and 12/12 h under light-emitting diode. Based on the results, it can be concluded that the determination of the optimal parameters for the growth and development of microalgae determines the production of their biomass, and such research should be carried out before starting the large-scale production process. In quantifying the biomass during cultivation, it is advantageous to use direct measurement methods.