The integration of nanotechnology into three-dimensional printing (3DP) offers huge potential and opportunities for the manufacturing of 3D engineered materials exhibiting optimized properties and multifunctionality. The literature relating to different 3DP techniques used to fabricate 3D structures at the macro- and microscale made of nanocomposite materials is reviewed here. The current state-of-the-art fabrication methods, their main characteristics (e.g., resolutions, advantages, limitations), the process parameters, and materials requirements are discussed. A comprehensive review is carried out on the use of metal- and carbon-based nanomaterials incorporated into polymers or hydrogels for the manufacturing of 3D structures, mostly at the microscale, using different 3D-printing techniques. Several methods, including but not limited to micro-stereolithography, extrusion-based direct-write technologies, inkjet-printing techniques, and popular powder-bed technology, are discussed. Various examples of 3D nanocomposite macro- and microstructures manufactured using different 3D-printing technologies for a wide range of domains such as microelectromechanical systems (MEMS), lab-on-a-chip, microfluidics, engineered materials and composites, microelectronics, tissue engineering, and biosystems are reviewed. Parallel advances on materials and techniques are still required in order to employ the full potential of 3D printing of multifunctional nanocomposites.

Ce fichier a été téléchargé à partir de PolyPublie, le dépôt institutionnel de Polytechnique MontréalThis file has been downloaded from PolyPublie, the institutional repository of Polytechnique Montréal http://publications.polymtl.ca

A three-dimensional finite element model of the induction welding of carbon fiber/polyphenylene sulfide thermoplastic composites is developed. The model takes into account a stainless steel mesh heating element located at the interface of the two composite adherends to be welded. This heating element serves to localize the heating where it is needed most, i.e. at the weld interface. The magnetic, electrical, and thermal properties of the carbon fiber/polyphenylene sulfide composite and other materials are identified experimentally or estimated and implemented in the model. The model predicts the temperature–time curves during the heating of the composite and is used to define processing parameters leading to high-quality welded joints. The effect of the heating element size and input current on the thermal behavior is investigated, both experimentally and using the developed model. The welds quality is assessed through microscopic observations of the weld interfaces, mechanical testing, and observations of the fracture surfaces. A comparison with two other welding processes, namely resistance welding and ultrasonic welding is finally conducted.

The objective of this work is to determine the effects of metal mesh heating element size on resistance welding of thermoplastic composites. The materials to be resistance-welded consisted of carbon fiber/poly-ether-ketone-ketone (CF/PEKK), carbon fiber/poly-ether-imide (CF/PEI) and glass fiber/PEI (GF/PEI). Four different metal mesh sizes were used as heating elements. The samples were welded in a lap shear joint configuration and mechanically tested. Maximum Lap Shear Strengths of 52, 47 and 33 MPa were obtained for the CF/PEKK, CF/PEI and GF/PEI specimens, respectively. The ratio of the heating element’s fraction of open area and wire diameter was shown to be the most important parameter to be considered when selecting an appropriate heating element size.