In this study, we report on the influence of mechanochemical activation on the chemical stability of amorphous solid dispersions made up of indomethacin and hydroxypropyl methyl cellulose (HPMC), poly­(vinylpyrrolidone) (PVP), poly­(vinylpyrrolidone vinylacetate) (PVPVA), or Soluplus. In agreement with our recently published work, all applied carriers were found to be prone to polymer degradation. Covalent bonds within the polymers were cleaved and mechanoradicals were generated. Furthermore, decomposition of indomethacin was also observed but occurred only in the presence of polymers. Hence, it is proposed that the generated mechanoradicals from the polymers are responsible for the chemical degradation of indomethacin. Our study also strongly suggests the existence of a critical polymer- and process-dependent molecular weight limit “M ∞”, below which only limited mechanodegradation takes place since the lower-molecular-weight polymer PVP K12PF had a less profound influence on the degradation of indomethacin in comparison to PVP K25.

A simple CE method was developed and validated for the simultaneous determination of chlordiazepoxide (CHL), amitriptyline, and nortriptyline (mixture I) or the determination of CHL and imipramine (mixture II) using the same BGE. Sertraline and amitriptyline were used as internal standards for the first and second mixtures, respectively. The method allows amitriptyline to be completely separated from its impurity and main metabolite nortriptyline, which can be quantified from 0.2 μg/mL. The separation was achieved using 20 mM potassium phosphate buffer pH 5 containing 12 mM β-cyclodextrin and 1 mM carboxymethyl-β-cyclodextrin. UV detection was performed at 200 nm and a voltage of 15 kV was applied on an uncoated fused-silica capillary at 25°C. These experimental conditions allowed separation of the compounds to be obtained in 7 min. Calibration graphs proved the linearity up to 40 μg/mL for CHL, up to 100 μg/mL for amitriptyline and imipramine, and up to 5 μg/mL for nortriptyline. The accuracy and precision of the method have been determined by analyzing synthetic mixtures and pharmaceutical formulations. The analytical results were quite good in all cases indicating that the method was linear, sensitive, precise, accurate, and selective for both mixtures.

No abstract

Using only a pH meter in combination with the selective electrodes, drug substance or drug product could be determined accurately in a few seconds. In addition, the in-house made electrodes were tested to monitor venlafaxine in serum. Acceptable results were achieved using the standard addition technique.