This paper shows the in situ synthesis of an hexyl acrylate monolith in PDMS microfluidic devices and its subsequent use as stationary phase for electrochromatography on chip. To overcome the ability of PDMS material to absorb organic monomers, surface modification of the enclosed channels was realized by UV-mediated graft polymerization. This grafting procedure is based on the preliminary adsorption of a photoinitiator onto the PDMS surface and polymerization of charged monomers. Next, hexyl acrylate monoliths were cast in situ using photopolymerization process. The chromatographic behavior of the monolithic column was confirmed by the successful separation of derivatized catecholamines in the PDMS device using a 30 mm effective separation length (100 microm x 100 microm section). Efficiencies reached up to 200,000 plates per meter.

This paper details a method for the separation and determination of ten benzodiazepines in urine using CEC-MS(TOF) and an hexyl acrylate-based porous monolith. The TOF mass spectrometer provides an exact mass of protonated benzodiazepines to three decimal places (1-6 ppm). This high selectivity along with the CEC separation, provides an effective method for the identification of benzodiazepines. Linearity is satisfactory for all compounds in the concentration range of 25-500 ng/mL for lorazepam and 12.5-500 ng/mL for the others. The RSDs are between 1.4-2.3% for retention times and 1.1-9.2% for relative areas. Using the monolithic stationary phase, a preconcentration step is achievable and permits an 75-140-fold improvement in sensitivity. This strategy permits the quantification of these drugs down to 1 ng/mL in urine. This method was used for the analysis of benzodiazepines in spiked urine samples.

Miniaturization of analytical instruments has attracted a wide interest in Analytical Chemistry over the past decade because of the advantages such as reduced reagent consumption and shorter analysis time. For chips involving separation, injection is a key step to achieve efficient and sensitive analysis. Electrokinetic injection mode is mostly used in chips because it is easier to generate flow motion in microsystems via electric potential control at channel extremities than pressure-driven flow. The injection step usually involves several intersecting channels. For each injection design, different injection modes can be done, depending on electric field sequences and distributions. This paper is an up-to-date review of these different modes on a chip.