A large-mode-area polymer photonic crystal fiber made of polymethyl methacrylate with the cladding having only one layer of air holes near the edge of the fiber is designed and proposed to be used in surface plasmon resonance sensors. In such sensor, a nanoscale metal film and analyte can be deposited on the outer side of the fiber instead of coating or filling in the holes of the conventional PCF, which make the real time detection with high sensitivity easily to realize. Moreover, it is relatively stable to changes of the amount and the diameter of air holes, which is very beneficial for sensor fabrication and sensing applications. Numerical simulation results show that under the conditions of the similar spectral and intensity sensitivity of 8.3 × 10−5–9.4 × 10−5 RIU, the confinement loss can be increased dramatically.

In this paper, a reflective photonic crystal fiber (PCF) sensor probe for temperature measurement has been demonstrated both theoretically and experimentally. The performance of the device depends on the intensity modulation of the optical signal by liquid mixtures infiltrated into the air holes of commercial LMA-8 PCFs. The effective mode field area and the confinement loss of the probe are both proved highly temperature-dependent based on the finite element method (FEM). The experimental results show that the reflected power exhibits a linear response with a temperature sensitivity of about 1 dB/°C. The sensor probe presents a tunable temperature sensitive range due to the concentration of the mixture components. Further research illustrates that with appropriate mixtures of liquids, the probe could be developed as a cryogenic temperature sensor. The temperature sensitivity is about 0.75 dB/°C. Such a configuration is promising for a portable, low-power and all-in-fiber device for temperature or refractive index monitoring in chemical or biosensing applications.

In this paper, a novel surface-enhanced Raman scattering (SERS) substrate based on Integrated Circuit (IC) process was designed, using photolithography, etching and other processes on the silicon wafer processing. Its surface morphology and Raman activity were characterized and tested. The relationship between the substrate’s photolithographic pattern and its Raman activity, stability and reproducibility has been analyzed and verified, and some suggestions for improvement of processing steps were given. This substrate can be used for the detection of biological proteins and provides a powerful research tool for life science and analytical chemistry research.

We propose a dual-wavelength intra-cavity absorption sensor based mode competition. The sensitivity of output power to relative cavity loss in different pump current is studied experimentally by defining a sensitivity enhancement factor (SEF). A measurement sensitivity of 158.5 times that of a single-pass absorption sensor is achieved.

No abstract