The removal of Pb(II), Cd(II), Cu(II), and Zn(II) from aqueous solutions using (un)modified Serbian interstratified montmorillonite/kaolinite clay as an adsorbent was investigated. The clay was modified by mechanochemical activation for different time periods. X-ray diffraction patterns and particle size distributions were used to characterize the samples. Batch adsorption studies were conducted to optimize various conditions. The adsorption equilibrium was established within 60 min, and the maximum adsorption occurred in the pH range of 4.5–6.5. The milled clays exhibited greater equilibrium adsorption capacities (q e) for all of the metals than the raw clay. A difference in q e values for clays milled for 2 and 19 h could be observed only for initial concentrations (C i) of ≥100 mg dm–3. This was related to the amorphization (i.e., exfoliation) of 19-h-milled clay particles. The adsorption equilibrium data of heavy metals on both raw and modified clays fit the Langmuir equation, although there were changes in the microstructure of the clay. The mechanochemical treatment of the clay reduced the amount of adsorbent necessary to achieve a highly efficient removal of heavy metals by a factor of 5. Thus, the mechanochemically treated interstratified clay can be considered as an efficient adsorbent for the simultaneous removal of divalent heavy metals.

No abstract

No abstract

No abstract

The removal of 60Co and 90Sr from the aqueous phase was tested using red mud - the fine grained residue from bauxite ore processing. This industrial waste represents a mixture of numerous minerals, mainly oxides and hydroxides of Fe, Al, Si, and Ti. Experiments were conducted as a function of contact time, pH, and pollutant concentrations. Kinetic data were well fitted with a pseudo-second order equation. The calculated rate constants and initial sorption rates indicated faster sorption of Sr2+ ions. Removal of both cations rapidly increased with the initial pH increase from 2.5 to 3.5. With the further increase of pH, Co2+ sorption was nearly constant (98%-100%), whereas Sr2+ removal remained at the same level to initial pH ~8 and gradually increased to 100% at pH 12. Equilibrium sorption data followed the Langmuir model, with the maximum sorption capacities of 0.52 mmol/g for Co2+ and 0.31 mmol/g for Sr2+. Sorbed cations exhibited high stability in distilled water. Desorption of Co2+ was also negligible in the presence of the competing Ca2+ cation, while 42%-25% of Sr2+ ions were desorbed depending on the previously sorbed amount. The results indicate that red mud is of potential significance as Co2+ and Sr2+ immobilization agent due to its high efficiency, abundance, and low-cost. [Projekat Ministarstva nauke Republike Srbije, br. 43009]