This study investigates the mechanisms as well as strategies for purification and characterization of potential enzymes involved in pathogenesis of entomopathogenic fungi. The test strain of Verticillium lecanii that was screened, during the present investigation, proved to be an efficient producer of protein and polysaccharide degrading enzymes (amylase, protease, and lipase), hence indicating versatility in biochemical mechanisms. Halo zones produced colony growth of V. lecanii on agar confirmed activity of protease, amylase and lipase enzyme by the V. lecanii isolate. Enzymatic Index (EI) observed were: Protease – 2.195, Amylase- 2.196, Lipase- 2.147. Spectrophotometric analysis of enzymatic activity of V.lecanii at five different pH – 3, 5, 7, 9, 11 revealed that highest proteolytic activity of the V. lecanii isolate was reported at pH 7 and 9 whereas proteolytic activity was minimum at acidic pH 3. Maximum amylolytic activity of V. lecanii on the 7th day of inoculation was at pH 3 i.e. in an acidic environment in contrast to neutral pH 7. Maximum lipolytic activity of V. lecanii was found at pH 7. Since enzyme production in entomopathogenic fungi is specific and forms an important criterion for successful development as well as improvement of mycoinsecticides, hence a significant conclusion from the present analysis is the degree of variation in secretion of enzymes in test strain of Verticillium lecanii.

PURPOSEPorcelain fused to metal (PFM) crowns provide the best treatment option for teeth that have a large or defective restoration. More than 20% of teeth with PFM crowns or bridges require non-surgical root canal treatment (NSRCT). This may be due to the effect of restorative procedures and the possible leakage of bacteria and or their by-products, which leads to the demise of the tooth pulp. Thus, this study was planned to compare the ability of the restorative materials to seal perforated PFM specimens.MATERIALS AND METHODSThe study evaluates the ability of amalgam, composite or compomer restorative materials to close perforated PFM specimen's in-vitro. Ninety PFM specimens were constructed using Ni-Cr alloys and feldspathic porcelain, and then they were divided into 3 groups: amalgam (A), composite + Exite adhesive bond (B) and compomer + Syntac adhesive bond (C). All the PFM samples were embedded in an acrylic block to provide complete sealing of the hole from the bottom side. After the aging period, each group was further divided into 3 equal subgroups according to the thermocycling period (one week for 70 cycles, one month for 300 cycles and three months for 900 cycles). Each subgroup was put into containers containing dye (Pelikan INK), one maintained at 5℃ and the other at 55℃, each cycle for 30 sec time. The data obtained was analyzed by SPSS, 2006 using one way ANOVA test and student t-test and significant difference level at (P<.01).RESULTSThe depth of dye penetration was measured at the interfaces of PFM and filling materials using Co-ordinate Vernier Microscope. The lowest levels of the dye penetration for the three groups, as well as subgroups were during the first week. The values of dye leakage had significantly increased by time intervals in subgroups A and C.CONCLUSIONIt was seen that amalgam showed higher leakage than composite while compomer showed the lowest level of leakage.

Aim:To assess dental professionals’ understanding of tobacco prevention and control.Materials and methods:In Sweden dental hygienists receive training in tobacco prevention and control. The study setting is Västerbotton County in the north of Sweden where a number of successful tobacco control initiatives have been established. A purposeful sample comprising five male and four female dental professionals and trainees was selected. Data were collected through in-depth semi-structured individual interviews and analysed using content analysis.Results:Informants acknowledged limited adherence to tobacco prevention. They were not confident of their knowledge of tobacco and non-communicable disease prevention and had limited awareness of global oral health policies. Reasons for poor adherence included professional fragmentation, lack of training, and the absence of reimbursement for time spent on prevention activities.Discussion:The success of efforts to reduce smoking in Västerbotton County is attributed to the network of local public health initiatives with very limited involvement by local dental professionals.Conclusions:The findings highlight the need to more actively engage the dental workforce in tobacco control and prevention. Moreover, it is important to recognise that dental professionals can be public health advocates for tobacco control and prevention at global, national and local levels.

No abstract

No abstract