Achieving efficient spatial modulation of phonon transmission is an essential step on the path to phononic circuits using "phonon currents". With their intrinsic and reconfigurable interfaces, domain walls (DWs), ferroelectrics are alluring candidates to be harnessed as dynamic heat modulators. This paper reports the thermal conductivity of single-crystal PbTiO 3 thin films over a wide variety of epitaxial-strain-engineered ferroelectric domain configurations. The phonon transport is proved to be strongly affected by the density and type of DWs, achieving a 61% reduction of the room-temperature thermal conductivity compared to the single-domain scenario. The thermal resistance across the ferroelectric DWs is obtained, revealing a very high value (≈5.0 × 10 −9 K m 2 W −1 ), comparable to grain boundaries in oxides, explaining the strong modulation of the thermal conductivity in PbTiO 3 . This low thermal conductance of the DWs is ascribed to the structural mismatch and polarization gradient found between the different types of domains in the PbTiO 3 films, resulting in a structural inhomogeneity that extends several unit cells around the DWs. These findings demonstrate the potential of ferroelectric DWs as efficient regulators of heat flow in one single material, overcoming the complexity of multilayers systems and the uncontrolled distribution of grain boundaries, paving the way for applications in phononics.

Since the discovery of Rochelle salt a century ago, ferroelectric materials have been investigated extensively due to their robust responses to electric, mechanical, thermal, magnetic, and optical fields. These features give rise to a series of ferroelectric‐based modern device applications such as piezoelectric transducers, memories, infrared detectors, nonlinear optical devices, etc. On the way to broaden the material systems, for example, from three to two dimensions, new phenomena of topological polarity, improper ferroelectricity, magnetoelectric effects, and domain wall nanoelectronics bear the hope for next‐generation electronic devices. In the meantime, ferroelectric research has been aggressively extended to more diverse applications such as solar cells, water splitting, and CO2 reduction. In this review, the most recent research progress on newly emerging ferroelectric states and phenomena in insulators, ionic conductors, and metals are summarized, which have been used for energy storage, energy harvesting, and electrochemical energy conversion. Along with the intricate coupling between polarization, coordination, defect, and spin state, the exploration of transient ferroelectric behavior, ionic migration, polarization switching dynamics, and topological ferroelectricity, sets up the physical foundation ferroelectric energy research. Accordingly, the progress in understanding of ferroelectric physics is expected to provide insightful guidance on the design of advanced energy materials.

Diesel engine particle emissions during transient operations, including emissions during FTP transient cycles and during active regenerations of a NOx adsorber, were studied using a fast Engine Exhaust Particle Sizer (EEPS). For both fuels tested, a No. 2 certification diesel and a low sulfur diesel (BP-15), high particle concentrations and emission rates were mainly associated with heavy engine acceleration, high speed, and high torque during transient cycles. Averaged over the FTP transient cycle, the particle number concentration during tests with the certification fuel was 1.2e8/cm 3 , about four times the particle number concentration observed during tests using the BP-15 fuel. The effect of each engine parameter on particle emissions was studied. During tests using BP-15, the particle number emission rate was mainly controlled by the engine speed and torque, whereas for Certification fuel, the engine acceleration also had a strong effect on number emission rates. The effects of active regenerations of a diesel NOx adsorber on particle emissions were also characterized for two catalyst regeneration strategies: Delayed Extended Main (DEM) and Post 80 injection (Post80). Particle volume concentrations observed during DEM regenerations were much higher than those during Post80 regenerations, and the minimum air to fuel ratio achieved during the regenerations had little effect on particle emission for both strategies. This study provides valuable information for developing strategies that minimize the particle formation during active regenerations of NOx adsorbers.

No abstract