In this work, the combined use of desorption by a continuous wave near-infrared diode laser and ionization by a dielectric barrier discharge-based probe (laser desorption dielectric barrier discharge ionization mass spectrometry (LD-DBDI-MS)) is presented as an ambient ionization method for the mass spectrometric detection of nonvolatile chemicals on surfaces. A separation of desorption and ionization processes could be verified. The use of the diode laser is motivated by its low cost, ease of use, and small size. To achieve an efficient desorption, the glass substrates are coated at the back side with a black point (target point, where the sample is deposited) in order to absorb the energy offered by the diode laser radiation. Subsequent ionization is accomplished by a helium plasmajet generated in the dielectric barrier discharge source. Examples on the application of this approach are shown in both positive and negative ionization modes. A wide variety of multiclass species with low vapor pressure were tested including pesticides, pharmaceuticals and explosives (reserpine, roxithromycin, propazine, prochloraz, spinosad, ampicillin, dicloxacillin, enrofloxacin, tetracycline, oxytetracycline, erythromycin, spinosad, cyclo-1,3,5,7-tetramethylene tetranitrate (HMX), and cyclo-1,3,5-trimethylene trinitramine (RDX)). A comparative evaluation revealed that the use of the laser is advantageous, compared to just heating the substrate surface.

An interface to allow on-line qualitative and quantitative full-plate detection and analysis of compounds separated by thin-layer chromatography (TLC) is presented. A continuous wave diode laser is employed as a desorption source. Atmospheric pressure chemical ionization mass spectrometry ionizes and subsequently identifies the desorbed sample molecules. Besides direct laser desorption on untreated TLC plates, graphite particles were used as a matrix to couple in the laser power and improve the efficiency of desorption.

This study introduced sandwich-structured copperglass substrates for standardization of laser desorption and plasma ionization. For standardized quantitative analysis, cavities were constructed which allow better reproducibility in droplet deposition and for laser application. Applying the diode laser, molten substrate material is incorporated into the glass, being trapped inside. Therefore, this method can be separated from laser ablation, achieving high ion signals without ablating material from the surface. Flexible microtube plasma (FμTP) was selected as the ionization source, this being the first time that laser desorption and FμTP ionization are coupled. This laser−plasma interface was applied to the detection of cholesterol, which showed a significantly improved limit of detection of 0.46 ng and linear dynamic range of 3 orders of magnitude in positive ion mode compared to other (ambient air mass spectrometry) methods. The main reason was the change of phase on the copper surface. The dehydrated molecule [M-H 2 O+H] + was the base peak of the spectrum and no further dissociation or fragmentation was observed. Blood plasma was spiked with cholesterol. In a 1:100 chloroform dilution, the presence of the plasma was neglectable and led to the same detection limits and linear dynamic range as in the cholesterol standard. No sample preparation or internal standards were needed for calibration. The physical effects of the surface modification were investigated, including the calculation of the laser beam waist to simplify the comparison and reproducibility of results.