The revolution of 3D-printing technology has caused an additional source of plastic waste, especially the new generation of composite filaments that are linked with the commercial fused deposition modeling process, adding pressure to find a sustainable solution to tackle the emerging waste problem. This study aims to investigate the mechanical and thermal properties of a blended recycled composite material produced by mixing two different 3D-printed reinforced composite wastes, carbon fiber CF/nylon, and glass fiber GF/nylon filaments that were mixed at different percentages using a hot extrusion procedure, tested by a tensile testing machine, and processed with five different weight ratios to study the impact of blend ratios on the material characteristics of the recycled composites and to find the optimum weight ratios with the most preferred properties. The results revealed that the maximum tensile strength of the GF/nylon composite was achieved with 60 wt%. The highest elastic modulus value was recorded at 60 wt% GF/nylon. Moreover, it was noted that at 80 wt% of GF/nylon, the ductility is at the peak value among the composites.

In this paper, Acrylonitrile-Butadiene-Styrene matrix composites reinforced with Nano-silica dioxide particles were examined and prepared to study their mechanical properties. The composite sheets were pre-prepared using the hot extrusion process. Due to its wide characteristics, silica dioxide additions can strengthen the usability and mechanical features of composite thermoplastics and polymers. Furthermore, introducing silica dioxide as a filler in various attributes can help to maintain the smooth flow of sufficient powders, reduce caking, and manage viscoelasticity. Despite its advantages, 3D printing generates a significant amount of waste due to limited prints or destroyed support structures. ABS is an ideal material to use because it is a thermoplastic and amorphous polymer with outstanding thermal properties that is also applicable with the FFF (Fused Filament Fabrication) technique. The findings showed that increasing the silica dioxide content reduces the tensile strength to 22.4 MPa at 10 wt%. Toughness, ductility, and yield stress values of ABS/silica dioxide composites at 15 wt% increased, indicating that the composite material reinforced by the silica dioxide particles improved material characteristics. It is essential to consider the impact of recycling in polymer reinforcement with fillers. Furthermore, the improved mechanical qualities of the composite material encourages successful ABS recycling from 3D printing, as well as the possibility of reusing it in a similar application.

No abstract

The utilization of waste materials like bio-binders and fine aggregates in construction is crucial for achieving environmentally sustainable building practices. By reusing these materials, we can significantly reduce waste production and preserve precious natural resources, making it a vital aspect of sustainable construction. This paper presents the experimental findings on the mechanical characteristics of using micro sand silica mixed with a bio-binder such as okra. The estimated mechanical properties that are discussed in this research include modulus, strength, and toughness. Okra with three different weight percentages (5, 10, and 15%) was mixed with four different micro-size particles (25, 250, 425, and 850 μm) and then compressed into a cylindrical sample. Okra demonstrated good adherence characteristics to sand silica particles, where the test results indicate that adding okra significantly affects the mechanical properties. Thermal analysis and SEM were employed to investigate the material degradation, surface morphology, and the internal structure of the composites. In general, it has been observed that at a particle size of 250 μm, the best mechanical properties have been achieved at a 15% weight ratio of the okra bio-binder.