No abstract

Bacterial cellulose produced by the gram-negative bacterium Gluconacetobacter xylinum was found to be an excellent native starting material for preparing shaped ultra-lightweight cellulose aerogels. The procedure comprises thorough washing and sterilization of the aquogel, quantitative solvent exchange and subsequent drying with supercritical carbon dioxide at 40 degrees C and 100 bar. The average density of the obtained dry cellulose aerogels is only about 8 mg x cm(-3) which is comparable to the most lightweight silica aerogels and distinctly lower than all values for cellulosic aerogels obtained from plant cellulose so far. SEM, ESEM and nitrogen adsorption experiments at 77 K reveal an open-porous network structure that consists of a comparatively high percentage of large mesopores and smaller macropores.

No abstract

No abstract

Bacterial cellulose aerogels overcome the drawback of shrinking during preparation by drying with supercritical CO2. Thus, the pore network of these gels is fully accessible. These materials can be fully rewetted to 100% of its initial water content, without collapsing of the structure due to surface tension of the rewetting solvent. This rehydration property and the high pore volume of these material rendered bacterial cellulose aerogels very interesting as controlled release matrices. Supercritical CO2 drying, the method of choice for aerogel preparation, can simultaneously be used to precipitate solutes within the cellulose matrix and thus to load bacterial cellulose aerogels with active substances. This process, frequently termed supercritical antisolvent precipitation, is able to perform production of the actual aerogel and its loading in one single preparation step. In this work, the loading of a bacterial cellulose aerogel matrix with two model substances, namely dexpanthenol and L‐ascorbic acid, and the release behavior from the matrix were studied. A mathematical release model was applied to model the interactions between the solutes and the cellulose matrix. The bacterial cellulose aerogels were easily equipped with the reagents by supercritical antisolvent precipitation. Loading isotherms as well as release kinetics indicated no specific interaction between matrix and loaded substances. Hence, loading and release can be controlled and predicted just by varying the thickness of the gel and the solute concentration in the loading bath.