Poly(N-vinylcarbazole)/polystyrene composites were prepared through simple radical polymerization of N-vinylcarbazole in the presence of polystyrene. Honeycomb-patterned composite thin films were fabricated by casting the composite solutions under humid conditions. The scanning electron microscopy (SEM) images of the resulting honeycomb pattern on the composites show a higher regular structure compared to those of films prepared from the poly(N-vinylcarbazole) homopolymer. The pressure-area isotherms and photoelectrochemical behaviors of the patterned films were also observed. The photoconductivity of the patterned thin films increased with increasing poly(N-vinylcarbazole) concentration. This enhancement is attributed to the effects of the honeycomb structures and the charge transfer across the donor/acceptor hybrid interface in the composite films.

Polypyrrole (PPy)–graphene oxide (GO) composites are synthesized via a soft‐chemical in situ method at different GO concentrations (10, 20, 30, 40, and 50 wt%) and with ammonium persulfate (APS) as the oxidant. The synthesized composites were characterized using Fourier transform infrared (FTIR) and ultraviolet‐visible light (UV–vis) spectroscopic studies, and their surface properties were analyzed using scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Characterization and surface morphology results indicate that PPy is adsorbed onto the graphene surfaces and/or fills the GO sheets. The temperature‐dependent DC conductivity of the polymer composite films in the 300–500 K range indicates a semiconducting behavior with increasing GO concentration in the PPy polymer. Based on morphological and conductivity studies, the large surface area and high aspect ratio of the in situ‐generated GO may have played an important role in the noticeable improvement in the electrical conductivity of the prepared composites. POLYM. COMPOS., 2011. © 2011 Society of Plastics Engineers

New polymer composites containing polyaniline‐carboxymethyl cellulose (PANI‐CMC) were prepared via the polymerization of aniline hydrochloride using different concentration (wt%) of sodium CMC using ammonium persulfate as an oxidant. The thermal stability and embedded crystallinity of the composites were investigated using thermogravimetric and X‐ray diffraction analysis method, respectively. The electrical properties of the composites were examined using temperature‐dependent DC conductivity within 300–500 K. As compared to pure polyaniline the composites with increasing CMC in the PANI‐CMC composites shows the enhancement in the higher crystallinity and thermal stability, and higher electrical conductivities under equivalent conditions. POLYM. COMPOS., 2012. © 2012 Society of Plastics Engineers

No abstract

A novel biocompatible composite of poly(ε‐caprolactone) (PCL) was synthesized via in situ ring‐opening polymerization method of ε‐caprolactone in the presence of reduced graphene oxide (RGO). Fourier transform infrared (FTIR) and X‐ray photoelectron spectroscopy (XPS) studies support a strong interaction between PCL and RGO. The crystallization behavior and thermal stability of these composites were studied using differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA), respectively. Honeycomb‐patterned thin films with regular structures were fabricated by casting the composite solution under humid conditions. The temperature‐dependent DC conductivity of the honeycomb‐patterned composite films was studied in the range of 290−330 K, which revealed a semiconducting behavior in the transport properties of the composite films. DC conductivity of the patterned films was increased by increasing the concentration of RGO in the composites and in the increased temperature. POLYM. COMPOS., 2012. © 2012 Society of Plastics Engineers