a b s t r a c tBridge displacement monitoring is one of the key components of bridge structural health monitoring. Traditional methods, usually based on limited sets of sensors mounted on a given bridge, collect pointlike deformation information and have the disadvantage of providing incomplete displacement information. In this paper, a Persistent Scatterer Interferometry (PSI) approach is used to monitor the displacements of the Nanjing Dashengguan Yangtze River high-speed railway bridge. Twenty-nine (29) European Space Agency Sentinel-1A images, acquired from April 25, 2015 to August 5, 2016, were used in the PSI analysis. A total of 1828 measurement points were selected on the bridge. The results show a maximum longitudinal displacement of about 150 mm on each side of the bridge. The measured displacements showed a strong correlation with the environmental temperature at the time the images used were acquired, indicating that they were due to thermal expansion of the bridge. At each pier, a regression model based on the PSI-measured displacements was compared with a model based on in-situ measurements. The good agreement of these models demonstrates the capability of the PSI technique to monitor long-span railway bridge displacements. By comparing the modelled displacements and dozens of PSI measurements, we show how the performance of movable bearings can be evaluated. The high density of the PSI measurement points is advantageous for the health monitoring of the entire bridge. Ó

Displacement monitoring of large bridges is an important source of information concerning their health state. In this paper, a procedure based on satellite Persistent Scatterer Interferometry (PSI) data is presented to assess bridge health. The proposed approach periodically assesses the displacements of a bridge in order to detect abnormal displacements at any position of the bridge. To demonstrate its performances, the displacement characteristics of two bridges, the Nanjing-Dashengguan High-speed Railway Bridge (NDHRB, 1272 m long) and the Nanjing-Yangtze River Bridge (NYRB, 1576-m long), are studied. For this purpose, two independent Sentinel-1 SAR datasets were used, covering a two-year period with 75 and 66 images, respectively, providing very similar results. During the observed period, the two bridges underwent no actual displacements: thermal dilation displacements were dominant. For NDHRB, the total thermal dilation parameter from the PSI analysis was computed using the two different datasets; the difference of the two computations was 0.09 mm/°C, which, assuming a temperature variation of 30 °C, corresponds to a discrepancy of 2.7 mm over the total bridge length. From the total thermal dilation parameters, the coefficients of thermal expansion (CTE) were calculated, which were 11.26 × 10−6/°C and 11.19 × 10−6/°C, respectively. These values match the bridge metal properties. For NYRB, the estimated CTE was 10.46 × 10−6/°C, which also matches the bridge metal properties (11.26 × 10−6/°C). Based on a statistical analysis of the PSI topographic errors of NDHRB, pixels on the bridge deck were selected, and displacement models covering the entire NDHRB were established using the two track datasets; the model was validated on the six piers with an absolute mean error of 0.25 mm/°C. Finally, the health state of NDHRB was evaluated with four more images using the estimated models, and no abnormal displacements were found.

Abstract. Full coverage and continuous deformation information retrieval are key aspects for dam health diagnosis. Ground-based synthetic aperture radar (GB-SAR) interferometry is used for the remote monitoring of the Geheyan Dam, China. Although the monitoring of a dam with ground-based interferometry is not an innovation, specific issues have been found out in the case study discussed due to the large dimension of the monitored structure. More than 400 images were used for interferogram generation. Radar signals reflected from the dam were carefully analyzed: a sort of tunneling effect caused by multireflection is observed, and deformations caused by water level and temperature variations were detected during a six-day monitoring campaign. Radar monitoring results were compared to the data recorded by plummets installed in the dam. The agreement between the displacements retrieved from interferometric data and the plummets demonstrates the capability of GB-SAR for deformation monitoring, with the advantage of large area coverage.

With the continuous expansion of the high-speed railway network in China, long-span railway bridges carrying multiple tracks demand reliable and fast testing procedures and techniques. Bridge dynamic behavior analysis is a critical process in ensuring safe operation of structures. In this study, we present some experimental results of the vibration monitoring of a four-track high-speed railway bridge with a metro–track on each side: the Nanjing–Dashengguan high-speed railway bridge (NDHRB). The results were obtained using a terrestrial microwave radar interferometer named IBIS-S. The radar measurements were interpreted with the support of lidar point clouds. The results of the bridge dynamic response under different loading conditions, including high-speed trains, metro and wind were compared with the existing bridge structure health monitoring (SHM) system, underlining the high spatial (0.5 m) and temporal resolutions (50 Hz–200 Hz) of this technique for railway bridge dynamic monitoring. The detailed results can help engineers capturing the maximum train-induced bridge displacement. The bridge was also monitored by the radar from a lateral position with respect to the bridge longitudinal direction. This allowed us to have a more exhaustive description of the bridge dynamic behavior. The different effects induced by the passage of trains through different tracks and directions were distinguished. In addition, the space deformation map of the wide bridge deck under the eccentric load of trains, especially along the lateral direction (30 m), can help evaluating the running stability of high-speed trains.

Interferometric synthetic aperture radar (InSAR) is a potential earth observation approach, and it has been demonstrated to have a variety of applications in measuring ground movement, urban subsidence and landslides. Currently InSAR provides the ability to map accurate DEM and measure ground deformation to sub-centimeter accuracy. However, many factors affect InSAR to measure ground movement since dam constructions are built in a large scale area with a complicated climate and unstable geology. This paper discusses potential applications of integrated InSAR and GPS to monitor a large-scale ground movement due to hydropower developments. The integration of InSAR and GPS can provide a cost-effective means for monitoring deformation of hydropower developments. Moreover, two novel methods, both the improved spatial interpolating method and estimation of 3D surface motion velocities method, are proposed and the experimental results and analysis are given in this paper.