The use of semiconductor nano-particles as temperature probes in luminescence chemical sensing applications is addressed. Temperature changes the intensity, the peak wavelength and the spectral width of the quantum dots luminescent emission in a linear and reversible way. Results are presented that show the feasibility of implementing a self-referenced intensity-based sensor to perform temperature measurements independent of the optical power level in the sensing system. A resolution of 0.3 • C was achieved. In addition, it is demonstrated that self-referenced temperature measurements at multiple points could be performed using reflection or transmission based optical fibre configurations.

A scheme for the simultaneous determination of oxygen and temperature using quantum dots and a ruthenium complex is demonstrated. The luminescent complex [Ru(II)-tris(4,7-diphenyl-1,10-phenanthroline)]2+ is immobilized in a non-hydrolytic sol-gel matrix and used as the oxygen sensor. The temperature information is provided by the luminescent emission of core-shell CdSe-ZnS semiconductor nanocrystals immobilized in the same material. Measurements of oxygen and temperature could be performed with associated errors of +/-2% of oxygen concentration and +/-1 degrees C, respectively. In addition, it is shown that while the dye luminescence intensity is quenched both by oxygen and temperature, the nanocrystals luminescent emission responds only to temperature. Results presented demonstrate that the combined luminescence response allows the simultaneous assessment of both parameters using a single optical fiber system. In particular, it was shown that a 10% error in the measured oxygen concentration, induced by a change in the sample temperature, could be compensated using the nanocrystals temperature information and a correction function.

The potential applications of luminescent semiconductor nanocrystals to optical oxygen sensing are explored. The suitability of quantum dots to provide a reference signal in luminescence-based chemical sensors is addressed. A CdSe-ZnS nanocrystal, with an emission peak at 520 nm, is used to provide a reference signal. Measurements of oxygen concentration, which are based on the dynamic quenching of the luminescence of a ruthenium complex, are performed. Both the dye and the nanocrystal are immobilized in a solgel matrix and are excited by a blue LED. Experimental results show that the ratio between the reference and the sensor signals is highly insensitive to fluctuations of the excitation optical power. The use of CdTe, near-infrared quantum dots with an emission wavelength of 680 nm, in combination with a ruthenium complex to provide a new mechanism for oxygen sensing, is investigated. The possibility of creating oxygen sensitivity in different spectral regions is demonstrated. The results obtained clearly show that this technique can be applied to develop a wavelength division multiplexed system of oxygen sensors.

No abstract

An all-optical scheme for simultaneous determination of oxygen and temperature is presented. A ruthenium complex immobilized in a non-hydrolytic sol-gel matrix is used as oxygen sensor. Temperature information is provided by CdSe quantum dots immobilized in the same material. While the dye luminescence is quenched by oxygen and temperature, the nanocrystals luminescence depends only on temperature. Results presented demonstrate that the combined luminescence response allows to simultaneously assess both parameters using a single optical fiber system.