We reversibly switch the state of a bistable atom by direct mechanical manipulation of bond angle using a dynamic force microscope. Individual buckled dimers at the Si(100) surface are flipped via the formation of a single covalent bond, actuating the smallest conceivable in-plane toggle switch (two atoms) via chemical force alone. The response of a given dimer to a flip event depends critically on both the local and nonlocal environment of the target atom-an important consideration for future atomic scale fabrication strategies.

Summary Background: Noncontact atomic force microscopy (NC-AFM) now regularly produces atomic-resolution images on a wide range of surfaces, and has demonstrated the capability for atomic manipulation solely using chemical forces. Nonetheless, the role of the tip apex in both imaging and manipulation remains poorly understood and is an active area of research both experimentally and theoretically. Recent work employing specially functionalised tips has provided additional impetus to elucidating the role of the tip apex in the observed contrast. Results: We present an analysis of the influence of the tip apex during imaging of the Si(100) substrate in ultra-high vacuum (UHV) at 5 K using a qPlus sensor for noncontact atomic force microscopy (NC-AFM). Data demonstrating stable imaging with a range of tip apexes, each with a characteristic imaging signature, have been acquired. By imaging at close to zero applied bias we eliminate the influence of tunnel current on the force between tip and surface, and also the tunnel-current-induced excitation of silicon dimers, which is a key issue in scanning probe studies of Si(100). Conclusion: A wide range of novel imaging mechanisms are demonstrated on the Si(100) surface, which can only be explained by variations in the precise structural configuration at the apex of the tip. Such images provide a valuable resource for theoreticians working on the development of realistic tip structures for NC-AFM simulations. Force spectroscopy measurements show that the tip termination critically affects both the short-range force and dissipated energy.

We use small-amplitude qPlus frequency modulated atomic force microscopy (FM-AFM), at 5 K, to investigate the atomic-scale mechanical stability of the Si(100) surface. By operating at zero applied bias the effect of tunneling electrons is eliminated, demonstrating that surface manipulation can be performed by solely mechanical means. Striking differences in surface response are observed between different regions of the surface, most likely due to variations in strain associated with the presence of surface defects. We investigate the variation in local energy surface by ab initio simulation, and comment on the dynamics observed during force spectroscopy.

Dimer configurations at the Si(100) surface have been studied with noncontact atomic force microscopy in the qPlus mode at 77 K, using both large (10 nm peak to peak) and small (0.5 nm peak to peak) oscillation amplitudes. In addition to the p(2×1), p(2×2), and c(4×2) reconstructions of the pristine surface, a variety of defect types including ad-dimers, vacancies, and split-off dimers have been imaged. Our data appear at odds with the currently accepted structural model for split-off dimers. At low oscillation amplitudes the degree of apparent dimer buckling can be “tuned” by varying the frequency shift set point.

We use a noncontact atomic force microscope in the qPlus configuration to investigate the structure and influence of defects on the Si(100) surface. By applying millivolt biases, simultaneous tunnel current data is acquired, providing information about the electronic properties of the surface at biases often inaccessible during conventional STM imaging, and highlighting the difference between the contrast observed in NC-AFM and tunnel current images. We also show how NC-AFM (in the absence of tunnel current) can be used to manipulate both the clean c(4 × 2) surface and dopant-related defects.